How to Do a Water Change (Without Killing Your Fish)

How to Do a Water Change (Without Killing Your Fish)

By TheCycledTank Editorial Team · Last updated: October 2026

aquarium water change

If you take one habit from this entire site, take this one. Regular partial water changes do more for fish health than any product, gadget, or medication — and most beginners either skip them or do them catastrophically wrong. The classic mistake: "cleaning" the tank by replacing all the water and scrubbing everything, which destroys the bacterial colony and shocks the fish. That's not maintenance. That's a reset button on months of progress.

This guide covers why water changes matter, exactly how much and how often, and the step-by-step procedure — plus what never to do.

Why water changes (your filter doesn't do this)

Your filter converts ammonia to nitrate — but nitrate just accumulates. Water changes are the only routine export for:

  • Nitrate — the end product of the nitrogen cycle. Kept under 40 ppm (under 20 for sensitive species) by dilution. See our parameter guide.
  • Dissolved organics — the invisible soup of fish waste products that no test kit measures. Hobbyists commonly argue that accumulated organics and hormones suppress growth and immunity; the mechanism is debated, but the water undeniably gets "stale."
  • Mineral and buffer replenishment — fresh water restores carbonate hardness (KH) that nitrification consumes, stabilizing pH. Our filter guide notes that pH crashes stall bacterial colonies; water changes are the prevention.

No filter, plant, or chemical removes all three. Dilution is the solution — literally.

How much, how often

The mainstream baseline: 25–30% weekly for a typically stocked freshwater community tank. The RSPCA's own fish-care guidance calls for weekly 30% changes to dilute what the biological filter can't break down; RSPCA Australia recommends 10–25% weekly once the tank is established. Adjust from there:

  • Heavily stocked or messy fish (goldfish, big cichlids): 30–50% weekly, or twice-weekly smaller changes.
  • Lightly stocked, planted tanks: 20% weekly or 25% biweekly can suffice — plants consume nitrate, but they don't replace dilution.
  • Saltwater: ~10% weekly is the common marine baseline — but marine changes have an extra step: salinity must match too. Mix salt into RO/DI water (not tap) to the tank's specific gravity, aerate it for several hours or overnight, and match temperature before adding. Newly mixed saltwater can have unstable pH and micro-bubbles; never pour just-mixed saltwater straight in.
  • Emergencies (ammonia/nitrite spike): 50% changes, repeated as needed — the one time big changes are correct.

"10% monthly" — the advice on some old care sheets — is not enough for most tanks. The math: if your tank produces 10 ppm nitrate a week and you change 25% weekly, nitrate settles around 40 ppm (10 ÷ 0.25). Change only 10% monthly (~2.5% per week) and it settles around 400 ppm (10 ÷ 0.025). Simplified model — it assumes constant nitrate production and no plant uptake — but the ratio is the point: frequency is the lever that matters. (Your tank's production rate will differ; the test kit tells you yours.)

The procedure, step by step

You need: a gravel vacuum/siphon, a clean bucket used only for the tank, water conditioner, and a thermometer. That's it.

  1. Unplug the heater if the water level will drop below it — heaters crack when exposed to air while hot. Switch off the filter too if the water level will fall near its intake — a canister or HOB running dry burns out the pump (see our filter guide). If the intake stays well submerged, the filter can keep running.
  2. Siphon out 25–30%. Start the siphon (gravity does the work once it's primed — bucket below tank level) and work the vacuum through the substrate (technique below).
  3. Prepare the new water in the bucket: fill, dose conditioner per the label, and match temperature to the tank within a couple of degrees (hobby rule of thumb: ~2°F/1°C; use a thermometer, not your hand — hands lie).
  4. Refill gently. Pour against a plate, your hand, or a decoration to avoid blasting the substrate. Slow is calm.
  5. Plug everything back in, check the filter restarted properly (HOBs sometimes need repriming), and you're done.

Total time: 15–30 minutes once you've done it twice (rule of thumb — bigger tanks and gravel-vacuuming add time).

Gravel vacuuming technique

Push the vacuum tube straight down into the substrate and hold it there a few seconds. Suction lifts debris and mulm up the tube while the heavier gravel tumbles back down — you'll see the dirt rise in a cloud and the gravel fall. Lift, move an inch over, repeat. Work systematically across the tank, doing roughly a third to half of the substrate each week (hobby rule of thumb — rotating sections avoids stripping too much at once).

Don't chase every speck. And in planted tanks, vacuum lightly around plants, not through root zones — established root systems are doing work down there.

Temperature matching and conditioner: the two non-negotiables

Temperature: new water should be within ~2°F/1°C of tank water. Thermal shock stresses fish and suppresses immunity — the "floating bag" acclimation ritual exists for the same reason. In winter, this means mixing hot and cold tap to match; in summer, check that the "cold" tap isn't actually warm.

Conditioner: dose every bucket, every time, before it goes in the tank. Two reasons: chlorine/chloramine kill fish and bacteria on contact, and the old advice to "let water sit 24 hours" only works for plain chlorine — chloramine doesn't evaporate, and many water suppliers use it. One more wrinkle: breaking chloramine's bond releases ammonia, which good conditioners also neutralize — but that's exactly why a cheap "chlorine only" product isn't enough. See the tap-water trap in our parameter guide. If you don't know which your supplier uses, assume chloramine and condition always.

What never to do

  • Never replace all the water. A 100% change destroys the bacterial colony's environment and shocks fish with completely new chemistry. There is no scenario where "start over with fresh water" beats fixing the actual problem.
  • Never wash filter media in tap water. Chlorine kills the colony. Rinse media in the old tank water you just siphoned out.
  • Never "deep clean" everything in one day. Gravel vacuum + filter scrub + decoration boil + full water change = a sterilized tank, not a clean one. Spread big jobs across weeks.
  • Never skip conditioner because "my tap is fine." Municipal water treatment changes without notice.
  • Never change water to "fix" cloudy water from a bacterial bloom without testing first — see our cloudy water guide. Big changes during a bloom can prolong it.

Quick answers

Can I do smaller changes more often? Yes — and the math favors it. Smaller, more frequent changes keep nitrate steadier than the same monthly volume done at once. 10–15% twice a week is a solid routine for sensitive tanks.

Do I vacuum every time? Light vacuuming weekly is ideal; deep-cleaning the whole substrate bed monthly at most. In heavily planted tanks, surface-skim debris and skip digging near roots.

My tap pH differs from my tank. Problem? Small differences are absorbed by a 25–30% change. As a rule of thumb, if tap and tank differ by more than ~0.5 pH, change smaller volumes more often, or investigate why the tank drifted — crashing KH is the usual suspect.

Can I use hot tap water to match temperature? Safer not to. Hot water sits in the heater tank and pipes, where it can pick up more dissolved metals (copper, lead from old plumbing) than cold water. Instead: fill with cold tap, then warm the bucket with a kettle or by mixing — or keep a spare aquarium heater for the bucket, as the RSPCA suggests. Conditioner handles chlorine either way.

Should I turn off the filter? Only if the water level drops near the intake. Otherwise leave it running — and if your HOB needs repriming after, do it immediately. A filter left off for hours starts losing bacteria (see our filter guide).

Where do I dump old tank water? Houseplants and gardens love it — it's free fertilizer (the RSPCA agrees). Down the sink or toilet is fine for ordinary tank water. Two exceptions: water from a tank being medicated (don't pour meds on your vegetable garden), and never into storm drains or waterways — plant fragments and pathogens don't belong in local ecosystems.

Where this comes from

Welfare authorities and extension

Hobby and industry sources

The 25–30% weekly figure is the hobby's mainstream consensus, endorsed by welfare authorities — not a lab-derived optimum. Tanks vary; the test kit is the final judge.