Work out the hydrogen peroxide dose for your tank in millilitres of the ordinary 3% solution — at the conservative 1 mL per gallon, with a half dose for shrimp and delicate plants and the published 1.5 mL-per-gallon upper bound shown as a ceiling, never a target. Spot-treat first: the filter-off timer and a hard cap keep a local patch from becoming a whole-tank overdose. This is a dose calculation only — it does not say hydrogen peroxide treats or cures anything, and if your fish are sick, see an aquatic vet. Everything runs in your browser; nothing is saved.
How it works
The dose. Dose (mL of 3% hydrogen peroxide) = tank volume in US gallons × rate. The default rate is the conservative 1.0 mL per gallon (AquariumSlab's rule of thumb: "one milliliter of 3% hydrogen peroxide per gallon of aquarium water"). In litres, gallons = litres ÷ 3.78541, so 1 mL per gallon is 0.264 mL per litre.
The half dose. For sensitive stock — shrimp and delicate plants such as mosses and Vallisneria — the tool halves its own default: 0.5 mL per gallon. Do not confuse this with Aquifarm's half dose of 0.75 mL per gallon, which is half of Aquifarm's 1.5 mL-per-gallon maximum, not half of this tool's 1.0 default. Both numbers are shown on the result so they are not mixed up.
The upper bound. Aquifarm's "generally accepted safe maximum dose" is 1.5 mL of 3% hydrogen peroxide per gallon. The tool shows it as a ceiling you must never exceed — never as a target. Its own example matches: a 20-gallon tank gets a maximum of 30 mL.
The dose conflict, stated plainly. Guides disagree, and there is no single authoritative dose. AquariumSlab's rule of thumb is 1 mL per gallon; Aquifarm's maximum is 1.5 mL per gallon; other guides give 1.5–2.5 mL per gallon or even 2–3 mL per gallon; and still other guides give 1 mL per 10 gallons — ten times lower. This tool defaults to the conservative 1 mL per gallon, shows 1.5 only as the published upper bound, and never uses the higher figures. It recommends no dose, no product, and no duration beyond the filter-off timer below.
Filter off. Turn off all filtration and powerheads for 30–60 minutes during and after a whole-tank dose, and 15–20 minutes for a spot treatment. Hydrogen peroxide is an indiscriminate sterilizer — run through the filter at full concentration it can harm the beneficial bacteria that power your nitrogen cycle.
Spot treatment. Spot mode gives no fixed spot-treatment millilitre number: apply only a small amount directly onto the target with a pipette or syringe, filter off, and treat the whole-tank dose for your tank as a hard cap. A spot treatment normally uses far less than the cap. Spot treatment is Aquifarm's preferred method.
3% only. Use the standard over-the-counter 3% solution — the ordinary brown bottle from a pharmacy or supermarket. Aquifarm is explicit: "DO NOT use any other concentration." No scaling for 6%, 12% or food-grade peroxide is offered, because no published source verifies a safe scaling for stronger concentrations in aquariums.
Concentration. At the 1.5 mL-per-gallon upper bound the water holds about 12 ppm of hydrogen peroxide (30 mL × 30.3 mg per mL = 909 mg, ÷ 75.7 L). The gap between treating algae and harming fish is narrow, and narrower in warm water — which is why the tool defaults below the maximum.
Worked example
20 US gallons, whole-tank dose, standard stock.
Tank 20 US gal. Whole-tank dose. Standard stock (sensitive box not ticked).
Dose = gallons × 1.0 mL/gal. Half dose = gallons × 0.5. Upper bound = gallons × 1.5. Filter off 30–60 min (whole-tank).
Standard dose = 20 × 1.0 = 20.0 mL. Half dose = 20 × 0.5 = 10.0 mL. Upper bound = 20 × 1.5 = 30.0 mL — matching Aquifarm's own example that a 20-gallon tank gets a maximum of 30 mL. Aquifarm's half dose = 20 × 0.75 = 15.0 mL.
20.0 mL of 3% hydrogen peroxide, filter off for 30–60 minutes. Sensitive stock would take the 10.0 mL half dose instead. Never more than 30.0 mL for this tank.
The same doses in litres: 75.7 litres is 20.0 US gallons (75.7 ÷ 3.78541), so the standard dose is again 20.0 mL. In spot mode the cap for the same tank is 20.0 mL (10.0 mL if sensitive), filter off for 15–20 minutes — but apply only a small amount directly onto the target, far less than the cap.
How to read your results
The headline is the dose in millilitres of 3% hydrogen peroxide. The stat grid shows the three numbers that keep the treatment inside its limits: the dose, the upper bound you must never exceed, and the filter-off timer for your method.
If the sensitive box is ticked, the dose is the half dose — 0.5 mL per gallon, half of this tool's 1.0 default. The result also shows Aquifarm's half dose (0.75 mL per gallon, half of its 1.5 maximum) so the two are not confused: use the 0.5 mL-per-gallon figure.
In spot mode the headline is a maximum, not an amount to use up: apply only a small amount directly onto the target and you will likely need far less than the cap. Watch your fish closely for an hour after dosing; if anything looks stressed, do a water change to dilute it. Whole-tank doses can set back filter bacteria, so test ammonia and nitrite for a few days after. Use fresh peroxide — it weakens once opened, and an old bottle can be well under label strength.
Common mistakes
- Using a stronger concentration. 3% only — never 6%, 12%, food-grade or industrial peroxide. The 35% food-grade bottle is corrosive and dangerous: dilute before use, wear gloves and eye protection, and never dose it directly.
- Exceeding the dose. The gap between treating algae and harming fish is narrow — never go above the 1.5 mL-per-gallon upper bound, and do not use the 2–3 mL-per-gallon figures some guides give.
- Leaving the filter on. Turn the filter and all powerheads off before you start, and keep them off for the full timer — 30–60 minutes whole-tank, 15–20 minutes spot.
- Guessing the dose. Measure every time with a syringe or medicine dropper, from the actual water in the tank — not the nominal size on the box.
- Whole-tank dosing a local patch. Spot-treat first: it puts far less peroxide into the water.
- Using it as a routine. Hydrogen peroxide is a treatment, not a routine — if you keep needing it, something underneath (too much light, unstable CO2, excess nutrients) needs fixing.
- Treating sick fish with peroxide instead of getting help. This tool says nothing about disease — sick fish need an aquatic vet.
- Repeating on a schedule. No repeat-dosing interval is given here: the tool does not schedule repeats, and no dose-per-interval rule is on file.
Doses by tank size (mL of 3%)
Standard dose at 1.0 mL per gallon, half dose at 0.5, Aquifarm's half dose at 0.75 (half of its 1.5 maximum), and the published upper bound at 1.5.
| Tank volume | Standard dose (1.0 mL/gal) | Half dose — sensitive stock (0.5 mL/gal) | Aquifarm half dose (0.75 mL/gal) | Upper bound — never exceed (1.5 mL/gal) |
|---|---|---|---|---|
| 10 gal | 10.0 mL | 5.0 mL | 7.5 mL | 15.0 mL |
| 20 gal | 20.0 mL | 10.0 mL | 15.0 mL | 30.0 mL |
| 40 gal | 40.0 mL | 20.0 mL | 30.0 mL | 60.0 mL |
| 75 gal | 75.0 mL | 37.5 mL | 56.25 mL | 112.5 mL |
Doses scale linearly with volume. Spot treatment has no fixed millilitre number in this table: the whole-tank dose for your tank is the cap, and a spot treatment normally uses far less than it.
FAQ
Why do guides disagree on the dose?
Because there is no single authoritative dose. AquariumSlab's rule of thumb is 1 mL per gallon, Aquifarm's maximum is 1.5 mL per gallon, other guides give 1.5–2.5 or 2–3 mL per gallon, and others give 1 mL per 10 gallons. This tool defaults to the conservative 1 mL per gallon and shows 1.5 only as a ceiling. It never uses the higher figures.
Can I use 6% or 12% peroxide and just use less?
No. Aquifarm is explicit: use the standard over-the-counter 3% solution and "DO NOT use any other concentration." No published source verifies a safe scaling for stronger concentrations in aquariums, so this calculator offers none.
Spot treatment or whole-tank dose?
Spot-treat first. Turn the flow off so the water is still, draw the peroxide into a pipette or syringe (no needle), and apply a small amount directly onto the target, filter off for 15–20 minutes. Whole-tank dosing is for widespread problems only — it puts far more peroxide into the water.
What is the filter-off time, and why does it matter?
30–60 minutes for a whole-tank dose, 15–20 minutes for a spot treatment. Hydrogen peroxide is an indiscriminate sterilizer: run through the filter at full concentration it can harm the beneficial bacteria that power your nitrogen cycle. Turn everything back on after the timer.
I keep shrimp — what do I do differently?
Tick the sensitive-stock box for the half dose (0.5 mL per gallon), and consider moving prized shrimp to a bucket of tank water for the treatment window. Spot-treat away from them: shrimp are the most sensitive stock in the tank.
How often can I repeat the treatment?
No repeat interval is given here — the tool does not schedule repeats, and no dose-per-interval rule is on file. Aquifarm mentions "once or twice a week" for a stubborn outbreak, but gives no dose-per-interval rule. If you keep needing it, fix the underlying cause instead: too much light, unstable CO2, or excess nutrients.
Does hydrogen peroxide cure fish disease?
This tool says nothing about disease — it is a dose calculation only and never says hydrogen peroxide treats or cures anything. Sick fish need an aquatic vet, not a dose from a calculator.
Can I use it every week as maintenance?
No. Aquifarm calls it "a treatment, not a routine." Weekly use keeps stressing fish, shrimp, plants and filter bacteria. If algae keeps coming back, the cause is light, CO2 or nutrients — fix that instead.
Sources
- Aquifarm — "Hydrogen Peroxide Aquarium: The Definitive Guide For Algae" (Hobby guide). aquifarm.com/hydrogen-peroxide-aquarium/
- AquariumSlab — "How to Safely Add Hydrogen Peroxide to Aquarium: A Step-by-Step Guide" (Hobby guide). aquariumslab.com/how-to-add-hydrogen-peroxide-to-aquarium/
- US FDA, Approved aquaculture drugs: Perox-Aid (35% hydrogen peroxide), label treatment concentrations for freshwater fish (Government). No URL for this source is on file, so it is listed by name.
- Haynes (ed.), CRC Handbook of Chemistry and Physics — 3% H₂O₂ solution density ~1.01 g/mL, giving ~30.3 mg H₂O₂ per mL (Reference). No URL for this source is on file, so it is listed by name.
- Yanong, R. P. E., Use of Hydrogen Peroxide in Finfish Aquaculture, FA157, University of Florida IFAS Extension — toxicity to fish and the effect of temperature (Extension). No URL for this source is on file, so it is listed by name.