Medication Dosing Calculator

Math only — read the label

This calculator does arithmetic, not treatment. Take the target ppm and the product concentration from the product label. Remove activated carbon before dosing, dose by actual water volume, and if fish worsen, seek advice from an aquatic veterinarian.

Volume units
Water in the tank, not the label size
From the product label — never guessed
From the product packaging

Dose (mL) = target ppm × litres ÷ (10 × concentration %). 1 US teaspoon = 4.92892 mL. Invertebrates are more sensitive than fish — start low and observe.

Your dose

Enter your actual water volume, the target from the label and the product concentration — the dose appears here, in millilitres and teaspoons.

Why use this calculator?

  • An exact dose every time — measured with a syringe, not a capful.
  • No under-dosing that lets disease survive and come back.
  • No overdosing that harms sensitive fish and invertebrates.
  • Dosed by actual water volume, so the number matches the tank in front of you.

Describe what you are seeing first with the Symptom Explorer, or measure the real water volume with the Tank Volume Calculator. · Back to Stocking & Fish Care

Enter your actual water volume, the target concentration from the product label and the product's concentration, and get the exact dose in millilitres and teaspoons. Math only — this never recommends a drug or a concentration. Everything runs in your browser; nothing is saved.

How it works

The tool does one piece of arithmetic: how many milligrams of active ingredient your water needs, divided by how many milligrams each millilitre of your product holds.

The formula. Dose (mL) = target ppm × litres ÷ (10 × concentration %). The 10 is not a fudge factor: 1 ppm = 1 mg per litre, so the milligrams needed are target × litres. A product at C% weight/volume holds C grams per 100 mL, which is 10 × C milligrams per mL. Divide milligrams by milligrams-per-mL and you get mL.

Actual water, not label size. Substrate, rock and decor take 10–20% of a tank's volume, so dosing for the label size overdoses. Measure the real water volume with the Tank Volume Calculator and enter that — the tool converts gallons to litres itself (1 US gallon = 3.78541 litres).

If your label gives a dose per volume instead of a ppm. The same scaling applies: dose = label amount × your volume ÷ label volume. A label of 5 mL per 10 gallons in 29 gallons of water is 5 × 29 ÷ 10 = 14.5 mL per dose. For a course, multiply by the number of doses; for a re-dose after a water change, multiply by the water-change percentage — and only re-dose if the label says to.

Teaspoons. The result also shows US teaspoons (1 US teaspoon = 4.92892 mL) for labels that speak in spoonfuls — but measure the dose with a syringe, not a spoon.

Worked example

20 gallons of actual water, target 2 ppm, from a 10% product.

Inputs

Actual water: 20 US gallons. Target: 2 ppm (from the product label). Product: 10%.

Formula

Dose (mL) = target ppm × litres ÷ (10 × concentration %).

Calculation

20 gal × 3.78541 = 75.71 litres. Milligrams needed = 2 × 75.71 = 151.42 mg. Product holds 10 × 10 = 100 mg/mL. Dose = 151.42 ÷ 100 = 1.51 mL. Teaspoons = 1.51 ÷ 4.92892 = 0.31.

Result

1.51 mL, about 0.31 US teaspoons — measured with a syringe.

A second example, by the label-scaling method: a 29-gallon tank, a label of 5 mL per 10 gallons, 5 doses in the course. One dose is 5 × 29 ÷ 10 = 14.5 mL; the course is 14.5 × 5 = 72.5 mL. After a 25% water change the re-dose is 14.5 × 25% = 3.63 mL — only if the label says to re-dose.

How to read your results

The big number is the dose in millilitres for one treatment of the water you entered. Under it, the stat grid shows the same dose in US teaspoons and the litres of actual water it was calculated for — check the litres first: if they do not match your tank, the dose will not either.

Below the stats, the rows are grouped. "Caution" is the invertebrate warning — shrimp and snails are more sensitive to most medications than fish. "OK" rows are reminders: dose by actual water, and measure with a syringe and write it down.

What to do next: remove activated carbon before dosing (it strips medication), dose once as calculated, and follow the product label — not this page — for duration and repeat doses. If fish worsen, seek advice from an aquatic veterinarian.

Common mistakes

  • Dosing by the tank's label size instead of the actual water volume — substrate, rock and decor take 10–20%, so the label size overdoses.
  • Guessing the target ppm. The target comes from the product label; this tool never suggests one.
  • Measuring with a capful instead of a syringe. Small doses need a syringe to be exact.
  • Leaving activated carbon in the filter — it strips medication from the water while you dose.
  • Re-dosing after a water change when the label does not say to. Re-dose only if the label says so, and only by the water-change percentage.
  • Treating the display tank when a bare quarantine tank is possible — quarantine protects plants, invertebrates and filter bacteria in the display.
  • Combining two medications without checking. Some combinations are toxic or cancel each other out — treat one at a time.
  • Forgetting oxygen. Many medications lower oxygen — run an air stone and watch for gasping.

Published bath levels — reference table

Milligrams of active ingredient for the published bath levels in Noga (2010). This is reference only: your target always comes from your product label, never from this table.

Level (from Noga, 2010)10 gal29 gal55 gal
Praziquantel, 2 mg/L75.7 mg219.6 mg416.4 mg
Metronidazole, 25 mg/L946 mg2,744 mg5,205 mg
Methylene blue, 2 mg/L75.7 mg219.6 mg416.4 mg
Potassium permanganate, 2 mg/L75.7 mg219.6 mg416.4 mg

Methylene blue is quoted as 1–3 mg/L in Noga; the table shows 2 mg/L. Turning milligrams into product: powder in grams = mg ÷ (% × 10); tablets = mg ÷ mg per tablet, rounded to the nearest quarter tablet; liquid in mL = mg ÷ mg per mL. Two checks: praziquantel at 2 mg/L in 40 gallons is 302.8 mg, or 0.30 g of pure powder; metronidazole at 25 mg/L in 10 gallons is 946 mg, or 3.75 tablets of 250 mg (rounded to the nearest quarter). If a dose is under a quarter tablet, dissolve one tablet in a measured volume of water and use the matching part of it.

FAQ

Where does the target ppm come from?

From your product label — never from this tool. The tool does arithmetic on a target you supply; it never recommends a drug or a concentration.

Why actual water volume, not the tank's label size?

Substrate, rock and decor take 10–20% of the volume, so a "20-gallon" tank rarely holds 20 gallons of water. Dosing for the label size overdoses. Measure the real volume with the Tank Volume Calculator.

Why does the tool ask for the product concentration?

The same target needs a different volume from different products: a 10% product holds 100 mg/mL, a 50% product holds 500 mg/mL. The concentration is on the packaging.

Can I re-dose after a water change?

Only if the label says to. The re-dose is the single dose × the water-change percentage — 14.5 mL × 25% = 3.63 mL in the worked example.

Should I remove carbon, and should I treat in quarantine?

Remove activated carbon during treatment — it strips medication. Treat in a bare quarantine tank when possible; it protects the plants, invertebrates and filter bacteria in the display tank.

Can I combine two medications?

Not without checking. Some combinations are toxic or cancel each other out — treat one at a time.

The dose is tiny — how do I measure 1.51 mL?

With a syringe, not a capful and not a spoon. For tablets, if a dose is under a quarter tablet, dissolve one tablet in a measured volume of water and use the matching part of it.

What if the fish get worse?

Seek advice from an aquatic veterinarian. This tool is arithmetic only — it does not diagnose, and it cannot tell you what is wrong.

Sources

  1. Noga, E. J., Fish Disease: Diagnosis and Treatment, 2nd ed., Wiley-Blackwell, 2010 (Textbook) — bath levels: praziquantel ~2 mg/L prolonged, metronidazole ~25 mg/L, methylene blue 1–3 mg/L, potassium permanganate 2 mg/L prolonged.
  2. Your product's own label (Manufacturer) — the target ppm and the product concentration this tool calculates from.
  3. TheCycledTank Tank Volume Calculator (Our tool) — measuring actual water volume.
  4. TheCycledTank Symptom Explorer (Our tool) — describing what you are seeing before you treat.

Related tools