CO2 Cylinder Duration Calculator

An estimate, not a measurement

Bubble size varies by bubble counter, so the days figure depends on the bubble size you enter — 0.16 mL is an assumption, not a standard — it matches the roughly 25 g/day per bps this site uses in the CO₂ Bubble Rate tool. If a cylinder empties much sooner than the estimate, check for leaks first, then suspect bigger bubbles or a solenoid that is not switching off at night. For freshwater planted tanks.

The weight of CO₂ in the cylinder, not the cylinder itself
Counted at your bubble counter
Hours the CO₂ runs each day — usually your light period, if you use a solenoid
An assumption, not a measurement — real bubbles run roughly 0.05–0.16 mL. Change it and the duration changes
Small losses at joints and fittings — 10% is a common allowance

Daily use = bubbles per second × bubble mL × 1.84 g/L × hours × 3.6 × (1 + leak). Days = cylinder grams ÷ daily grams; months = days ÷ 30.4. Worked example: a 5 lb cylinder (2,268 g) at 2 bps, 9 h/day, 0.16 mL bubbles and 10% leak uses 20.98 g/day and lasts 108 days — about 3.6 months.

How long will the cylinder last?

Pick a cylinder size and enter your bubble rate and hours per day — the days, weeks and months it lasts appear here, with a refill date.

Why use this calculator?

  • Know when your cylinder will run out — in days, weeks and months, with a refill date — instead of being surprised by an empty bottle.
  • See the daily grams your bubble rate actually uses, so a change in bps shows up as a change in refill frequency.
  • Compare cylinder sizes before you buy, from a 20 oz paintball bottle to a 20 lb cylinder.
  • Put a number on the leak allowance, so a cylinder that empties early points at a leak instead of a mystery.
  • See how much a solenoid saves versus running CO₂ all day, in days of cylinder life.

Mixing DIY CO₂ instead? The Citric Acid CO2 Calculator works out the recipe and how long a batch lasts. Pick a starting bubble rate with the CO2 Bubble Rate Calculator. · Back to Planted Tank

Work out how long your CO2 cylinder lasts at your bubble rate and photoperiod — in days, weeks and months, with a refill date, so an empty bottle never surprises you. Everything runs in your browser; nothing is saved.

How it works

The calculator is a mass balance: it works out how many grams of CO2 leave the cylinder each day, then divides the gas in the cylinder by that daily use.

The formula. Daily use (g/day) = bubbles per second × bubble size (mL) × 1.84 g/L × hours per day × 3.6 × (1 + leak). Days = cylinder grams ÷ daily grams. Weeks = days ÷ 7. Months = days ÷ 30.4. The 3.6 folds the seconds-per-hour (3,600) and the millilitres-per-litre (1,000) into one number, and the leak term adds your allowance for small losses at joints and fittings.

The density. CO2 gas weighs 1.84 g/L at 20 °C — the CRC Handbook figure, and Engineering Toolbox lists 1.842 kg/m3 at NTP 20 °C. That is the only physical constant in the calculation; everything else is your setup.

The bubble size. No published standard fixes a bubble-counter bubble at one size — forum measurements put real bubbles anywhere from about 0.05 mL to about 0.16 mL. This calculator defaults to 0.16 mL because that matches the sibling bubble-rate tool's ~25 g/day at 1 bps (0.16 mL × 1.84 g/L × 86,400 s/day = 25.4 g/day), so the two CO2 tools agree with each other. Bubble size stays a user-entered input, labelled as an assumption — change it and the duration changes with it.

The cylinder sizes. The weight is the gas, not the bottle: 20 oz paintball 567 g, 24 oz paintball 680 g, 2.5 lb 1,134 g, 5 lb 2,268 g, 10 lb 4,536 g, 20 lb 9,072 g, 1 kg 1,000 g, 2 kg 2,000 g — or enter your own weight in grams from the cylinder label.

Worked example

5 lb cylinder (2,268 g), 2 bps, 9 hours a day, 0.16 mL bubbles, 10% leak.

Inputs

Cylinder 2,268 g, bubble rate 2 bps, 9 h/day, bubble size 0.16 mL, leak allowance 10%.

Formula

Daily use = bps × bubble mL × 1.84 × hours × 3.6 × (1 + leak). Days = cylinder grams ÷ daily use.

Calculation

2 × 0.16 × 1.84 × 9 × 3.6 = 19.08 g; × 1.1 = 20.98 g/day. Days: 2,268 ÷ 20.98 = 108.1, about 108 days. Weeks: 108.1 ÷ 7 = 15.4. Months: 108.1 ÷ 30.4 = 3.6.

Result

About 108 days — 15.4 weeks, about 3.6 months — at 20.98 g/day. Refill around today + 108 days.

The same setup with smaller bubbles shows how much the assumption matters: at 0.1 mL instead of 0.16 mL, daily use falls to 13.12 g/day and the cylinder lasts 173 days — about 5.7 months. If your counter makes small bubbles, the cylinder lasts far longer than the default figure says.

How to read your results

The headline is the days the cylinder lasts, with your cylinder weight, bubble rate and hours underneath. The stat grid shows the three numbers to plan around: the days, the daily grams, and the refill date — order before that date, not on it.

The figures table breaks the calculation open so you can check it: daily use with its formula, the days as cylinder grams divided by daily grams, the weeks and months, and the refill date as today plus the days. Below that, the check rows explain the result: the worked example to compare against, what to do if a cylinder empties early, and why the gauge cannot be trusted.

What to do next: weigh the cylinder when it is new and write the weight on it, then weigh it again when the estimate says it should be nearly empty. Weight lost is CO2 used — the pressure gauge stays steady while any liquid CO2 remains and only falls in the last few days, so it tells you almost nothing until it is nearly too late.

Common mistakes

  • Counting the bottle as the gas. Cylinder size is the weight of the CO2 inside — the steel bottle weighs far more. A "5 lb cylinder" holds 2,268 g of gas; the bottle itself is extra.
  • Trusting the pressure gauge. It stays steady while any liquid CO2 remains and falls only in the last few days — weigh the cylinder instead.
  • Forgetting the second tank on a manifold. A second tank adds its bubbles to the total, so count both bubble rates or the estimate will be far too generous.
  • Leaving the leak allowance at 0 when joints leak. A small leak is normal at fittings; 10% is a common allowance, and a cylinder that empties much sooner than the estimate usually has a leak — test joints with soapy water.
  • Running CO2 24 hours a day. A solenoid on a timer cuts use by more than half versus running all day; double the bubble rate or the hours and the cylinder lasts half as long.
  • Assuming bubble size is standard. Real bubbles run roughly 0.05–0.16 mL, so the duration moves with your counter — measure or accept the range.
  • Ordering on the refill date. Order before it: a cylinder can run faster as pressure drops near the end, and delivery takes days.

Days per fill at 9 hours a day

Days a fill lasts at 0.1 mL bubbles and 10% leak, running 9 hours a day. Double the bubble rate and the cylinder lasts half as long.

Cylinder1 bps2 bps3 bps
20 oz paintball (567 g)86 days43 days29 days
2.5 lb (1,134 g)173 days86 days58 days
5 lb (2,268 g)346 days173 days115 days
10 lb (4,536 g)692 days346 days231 days
20 lb (9,072 g)1,383 days692 days461 days

At 0.1 mL bubbles a 20 oz paintball bottle lasts about three months at 1 bps — the same rate that stretches a 5 lb cylinder past eleven months. The table assumes 0.1 mL bubbles; with the 0.16 mL default the same setups last shorter (a 5 lb cylinder at 2 bps lasts 108 days, not 173).

FAQ

How do I know how much gas is left?

Weigh the cylinder. Weight lost is CO2 used: a 5 lb cylinder that has lost 1,134 g is half empty, whatever the gauge says. Write the full weight on the bottle when it is new so you have something to compare against.

Why did my cylinder empty early?

Check for leaks first — test joints with soapy water. Then suspect bigger bubbles than the 0.16 mL default, or a solenoid that is not switching off at night. A cylinder that empties in half the estimated time is usually leaking or running twice the hours you entered.

What bubble size should I enter?

0.16 mL is the default, and it is an assumption, not a measurement. Real bubble-counter bubbles run roughly 0.05–0.16 mL. If you know your counter makes small bubbles, enter a smaller figure and watch the duration grow; if cylinders keep emptying early, your bubbles are bigger than 0.16 mL.

Does a bigger cylinder use less gas?

No — it holds more gas, so it needs refilling less often. Daily use depends only on your bubble rate, hours and bubble size. A 10 lb cylinder lasts twice as long as a 5 lb one at the same rate, but it does not change what the tank uses per day.

Solenoid or 24 hours a day?

A solenoid on a timer cuts use by more than half versus running 24 hours a day, because the gas is off for the 15–16 hours the lights are out. Plants do not use CO2 in the dark, so the overnight gas only pushes the pH down. The saving shows up directly in days of cylinder life.

Paintball bottle or 5 lb cylinder?

It is a refill-frequency question, not a gas question. At 1 bps, 9 hours a day, 0.1 mL bubbles and 10% leak, a 20 oz paintball bottle lasts 86 days and a 5 lb cylinder lasts 346 days — about four times as long, because it holds about four times the gas. Small bottles suit small tanks and low rates; the refills get tedious otherwise.

What if I run two tanks off one cylinder?

Add the bubble rates together first, then enter the total. Two tanks at 1 bps each use gas like one tank at 2 bps — the cylinder lasts half as long as either tank alone would suggest.

Sources

No URLs are on file for the sources below — they are listed by name, as cited in the research notes and the tool's own notes.

  1. Haynes (ed.), CRC Handbook of Chemistry and Physics — CO2 gas density about 1.84 g/L at 20 °C, about 1.81 g/L at 25 °C (Textbook).
  2. Engineering Toolbox — CO2 density 1.842 kg/m3 at NTP 20 °C (Reference).
  3. UKAPS forum measurements — Tropica bubbles about 0.11 mg, about 0.06 mL (Hobby practice).
  4. Method: mass balance — daily grams = bps × bubble mL × 1.84 mg/mL × hours × 3,600 ÷ 1,000 × (1 + leak); days = cylinder grams ÷ daily grams (Our method).

Related tools