Work out how much water your tank really holds — after glass thickness, the gap below the rim, substrate and rock — so medication, salt and conditioner are dosed by the real volume, not the number on the box. A 48 × 13 × 21 in "55-gallon" tank with 3/8 in glass, a 1 in rim gap, 2 in of substrate and 5% rock holds 56.7 gallons gross but only 42.0 US gallons (158.8 L) of actual water. Everything runs in your browser; nothing is saved.
How it works
The calculator starts from the outside dimensions and takes off each deduction in turn, so you can see where the volume goes. All lengths are in inches; the formulas use the US gallon (231 in³).
Gross volume. Length × width × height ÷ 231. For the worked example: 48 × 13 × 21 = 13,104 in³ ÷ 231 = 56.73 gallons. That is the number on the box.
Inside, to the waterline. Inner length and width each lose twice the glass thickness (the glass is on both sides), and the water depth is the height minus the bottom glass minus the rim gap. Inner volume = (L − 2t) × (W − 2t) × (H − t − gap) ÷ 231. For the example: (48 − 0.75) × (13 − 0.75) × (21 − 0.375 − 1) = 47.25 × 12.25 × 19.625 = 11,359 in³ ÷ 231 = 49.17 gallons. Glass and the rim gap alone take 7.6 gallons off the gross figure.
Substrate. Substrate volume = inner length × inner width × substrate depth ÷ 231. For the example: 47.25 × 12.25 × 2 = 1,158 in³ ÷ 231 = 5.01 gallons. The substrate is counted at its full bulk volume — deliberately. Water does fill the gaps between grains, so the true displacement is a little less, but the pore fraction varies by source and grain type (hydrology references put unconsolidated sand and gravel porosity at roughly 25–50%), and no single factor is authoritative. Counting the full bulk volume makes the net figure a slightly low, conservative estimate — the safe direction for dosing, since dosing by a slightly low volume underdoses rather than overdoses.
Rock and decor. Rock takes the percentage you enter of what is left after glass, rim gap and substrate — not of the gross volume. That base is stated because sources differ and most never say. For the example: 49.17 − 5.01 = 44.16 gallons left; 5% of that is 2.21 gallons.
Net volume. Inner volume − substrate − rock. For the example: 49.17 − 5.01 − 2.21 = 41.95 gallons, shown as 42.0. Litres = US gallons × 3.78541 (158.8 L); UK gallons = litres ÷ 4.54609 (34.9 UK gal).
Water weight. Freshwater weighs about 1 kg per litre, 8.34 lb per US gallon — so 158.8 kg (349.9 lb) for the example. Saltwater weighs about 2.5% more (about 8.55 lb per US gallon); the weight shown is freshwater only. The weight is water alone — add the glass, substrate, decor and stand on top.
Scope. Rectangular tanks only. Bowfront, cylinder, hexagon and corner tanks need their own formulas, and a sump, filter or plumbing adds water this calculator does not count — add the sump's running volume separately if you dose the whole system.
Worked example
A standard 55-gallon tank: 48 × 13 × 21 in outside, 3/8 in (0.375 in) glass, water 1 in below the rim, 2 in of substrate, 5% rock and decor.
48 × 13 × 21 in · Glass 0.375 in · Rim gap 1 in · Substrate 2 in · Rock 5%.
Net = inner volume − substrate − rock, where inner = (L − 2t) × (W − 2t) × (H − t − gap) ÷ 231.
Gross 56.73 gal. Inner 47.25 × 12.25 × 19.625 ÷ 231 = 49.17 gal. Substrate 5.01 gal. Rock 5% of 44.16 = 2.21 gal. Net 49.17 − 5.01 − 2.21 = 41.95 gal.
42.0 US gallons (158.8 L, 34.9 UK gal), weighing 158.8 kg (349.9 lb). Dosing the rated 56.7 gal into 42.0 gal of water would overdose by about 35%.
The same tank with thinner glass holds more: with 6 mm (0.236 in) glass instead of 3/8 in, the net is 43.5 US gallons (164.7 L) — which matches the published figure for that setup. And with no substrate and no rock at all, the net is just the inside-to-waterline volume, 49.2 gallons.
How to read your results
The verdict is the net water volume in US gallons — the number to dose and stock by. Under it, the gross figure is shown for comparison, and the stat grid gives the net in litres and the water weight in kilograms.
Below the stats, the checks are grouped. The OK rows walk through every deduction separately — gross, inside-to-waterline, substrate plus rock — so you can see which one is eating your volume. The Caution row is the dosing warning: it states the overdose percentage if you dosed the rated size into the real water. If there is a fix, it sits under "How to fix it": dose for the net volume, not the rating.
Remember the net is conservative on purpose. Substrate is counted at full bulk volume even though water fills the gaps between grains, so the true volume is a little higher. For an exact number, fill and measure with a bucket — that beats any formula.
Common mistakes
- Dosing by the label. A "55-gallon" tank with substrate and rock can hold barely 42 gallons of water — dosing for 57 overdoses by about 35%.
- Taking the glass off once. Inner length and width each lose twice the glass thickness — there is glass on both sides.
- Forgetting the rim gap. Water kept an inch below the rim is an inch of height with no water in it, across the whole footprint.
- Measuring substrate at the deepest point only. Sloped substrate needs an average — measure front, middle and back and average them.
- Rock as a share of the gross volume. In this calculator the rock percentage is of what is left after glass, rim gap and substrate — a different base gives a different answer, so check which base any other calculator uses.
- Leaving substrate at 2 in for a bare-bottom tank. Bare-bottom means 0 — otherwise you are subtracting water that is really there.
- Forgetting the sump. This calculator counts the display tank only. If you dose the whole system, add the water the sump holds while the return pump is running.
- Using the freshwater weight for a reef tank. Saltwater weighs about 2.5% more — the weight shown here is freshwater only.
Actual water in standard tanks
Net water for eight standard tanks, worked out with this calculator's formula: 1 in rim gap, 2 in of substrate, no rock. Glass is 1/4 in up to 29 gal, 3/8 in from 40 to 75 gal, and 1/2 in at 90 gal and above. Small tanks lose the biggest share — the gap and substrate are a larger part of their height.
| Standard size | Outside L × W × H (in) | Gross (US gal) | Net water (US gal) | Net water (L) | Less than gross |
|---|---|---|---|---|---|
| 10 gal | 20 × 10 × 12 | 10.4 | 7.0 | 26.6 | 32% |
| 20 long | 30 × 12 × 12 | 18.7 | 12.9 | 48.6 | 31% |
| 29 gal | 30 × 12 × 18 | 28.1 | 21.7 | 82.0 | 23% |
| 40 breeder | 36 × 18 × 16 | 44.9 | 33.2 | 125.8 | 26% |
| 55 gal | 48 × 13 × 21 | 56.7 | 44.2 | 167.2 | 22% |
| 75 gal | 48 × 18 × 21 | 78.5 | 62.2 | 235.4 | 21% |
| 90 gal | 48 × 18 × 24 | 89.8 | 70.9 | 268.4 | 21% |
| 125 gal | 72 × 18 × 21 | 117.8 | 91.4 | 346.1 | 22% |
Add rock and the net falls further — the worked example's 5% rock takes the 55-gallon tank from 44.2 down to 42.0 gallons.
FAQ
How much water is actually in my tank?
Less than the label, always. A standard 55-gallon tank holds about 44 gallons of water with a 1 in rim gap and 2 in of substrate and no rock, and about 42 gallons with 5% rock. Small tanks lose a bigger share — a 10-gallon tank holds only about 7 gallons on the same assumptions. Enter your own measurements above for your tank's number.
Why does substrate only take part of its volume?
Because water fills the gaps between the grains — only the solid grains displace water. Some calculators apply a pore fraction (about 40% pores for gravel and sand, 50% for aquasoil, so only 60% or 50% of the bed volume displaces water). This calculator does not: the pore fraction varies by source and grain type, and no single factor is authoritative, so it counts the full bulk volume and the net comes out slightly low — the safe direction for dosing.
How is rock counted — by weight or by percentage?
By percentage here: the share you enter of the volume left after glass, rim gap and substrate. By weight, dry limestone and aragonite run about 2.7 g/cm³, which works out to roughly 10.25 cubic inches — about 0.044 US gallons — per pound, so 50 lb of rock displaces just over 2 gallons. Either way, use dry weight: wet live rock weighs more.
Do I dose for the label size or the actual volume?
The actual volume — including the sump, if you dose the whole system. Dosing for the label overdoses by roughly 10–20% on a typical setup and about 35% on the worked example, which matters most for copper and other narrow-margin treatments. Always check the product's own instructions as well.
Is there a quick estimate without measuring everything?
As a rough guide only: take about 5% off the label for a bare-bottom tank, 10% for gravel plus decor, 15% for heavy rock or a full aquascape, and 20% for a deep sand bed with reef rock. Those are rules of thumb — measure and use the detailed calculator when the dose matters.
How do I find my glass thickness?
Measure the edge of the glass at the top with calipers, or check the manufacturer's spec sheet. Typical glass is 1/4 in on small tanks, 3/8 in up to about 75 gallons, and 1/2 in on large tanks; rimless tanks run thicker than rimmed ones of the same size.
Should I include my sump or refugium?
Not in this calculator — it counts the display tank only. For a whole-system dose, add the water the sump holds while the return pump is running, and dose the total system volume.
Sources
- NIST Special Publication 811 — US gallon = 231 in³ = 3.785411784 L; Imperial gallon = 4.54609 L (Standard).
- NIST Handbook 44, Appendix C — US gallon = 231 in³; pound = 453.59237 g (Standard).
- Fetter, C. W., Applied Hydrogeology — typical porosity of unconsolidated sand and gravel, roughly 25–50% (Textbook).
- Haynes, W. M. (ed.), CRC Handbook of Chemistry and Physics — densities of calcite (2.71 g/cm³) and aragonite (2.93 g/cm³) (Reference).
- DexoCalc — Aquarium Volume Calculator, same 48 × 13 × 21 in tank with 6 mm glass: about 43.5 US gal (Reference). dexocalc.com/pet-calculators/aquarium-volume-calculator/
- AquariumCalculator.net — Aquarium Dimensions to Gallons Calculator, glass correction, 1 in rim gap, substrate as bulk volume (Reference). aquariumcalculator.net/aquarium-dimensions-to-gallons-calculator/
- The Volume Calculator — NIST SP 811 conversion factors (Reference). thevolumecalculator.com