Reef Alkalinity Calculator

Raise no more than about 1 dKH per day

Fast alkalinity swings stress SPS corals more than the low reading itself. Dissolve each day's dose in RO water first and add it slowly to high flow. Dose alkalinity and calcium at different times and places — adding them together precipitates calcium carbonate ("snow").

Volume units

Display plus sump, minus rock and substrate

From your alkalinity test kit, in dKH

Your own target — this tool never picks one for you

Baking soda slightly lowers pH; soda ash raises it

Default 1 dKH/day; about 1.4 dKH/day is the upper limit

Shortfall in meq = alkalinity gap in dKH × 0.3566 meq/L per dKH × litres (APHA Standard Methods 2320). Baking soda in grams = meq × 84.007 ÷ 1,000; soda ash = meq × 52.995 ÷ 1,000 (CRC Handbook molar masses). Worked example: a 100-gallon system (378.5 L) from 7 to 9 dKH needs 270.0 meq = 22.7 g baking soda (11.3 g/day over 2 days), or 14.3 g soda ash. Teaspoons are approximate (1 level teaspoon of baking soda ≈ 4.6 g); weigh the dose when you can.

Your alkalinity dose

Enter your volume, current and target alkalinity — the buffer dose in grams appears here, split across days so the rise stays safe.

Why use this calculator?

  • Get a one-off buffer correction in weighed grams — not a daily two-part dose, and not a guess from spoonfuls.
  • See the correction split across days, so a stocked tank never rises more than about 1 dKH a day.
  • Compare baking soda and soda ash for the same correction, so the pH effect of each is part of the choice.
  • Know where the numbers come from — the meq formula is shown, with the APHA and CRC sources behind it.

Work out your daily two-part dose with the Reef Dosing Calculator, check the rest of the water with the Water Parameter Checker, or find your true water volume with the Tank Volume Calculator. · Back to Saltwater & Reef

Work out how much baking soda or soda ash raises your reef alkalinity by the amount you need — in weighed grams, split across days so a stocked tank never rises more than about 1 dKH a day. See both buffers for the same correction, so the pH effect of each is part of the choice. Everything runs in your browser; nothing is saved.

How it works

Alkalinity is the water's ability to resist a pH fall, measured in dKH (degrees of carbonate hardness). The tool works in milliequivalents, the chemist's unit for alkalinity, because the buffer chemistry is exact in meq and only approximate in spoonfuls.

1 dKH = 0.3566 meq/L. That figure comes from APHA Standard Methods 2320: 1 dKH is 17.86 mg/L as calcium carbonate, and dividing by 50.04 mg per meq gives 0.3569 meq/L — the tool uses the published APHA figure of 0.3566.

Shortfall (meq) = alkalinity gap (dKH) × 0.3566 × litres. The gap is your target minus your current reading, and the litres are your net system volume — display plus sump, minus rock and substrate.

Baking soda (g) = meq × 84.007 ÷ 1,000. Sodium bicarbonate, NaHCO3, weighs 84.007 g per mole and carries one equivalent per mole.

Soda ash (g) = meq × 52.995 ÷ 1,000. Sodium carbonate, Na2CO3, weighs 105.99 g per mole and carries two equivalents per mole, so 52.995 g per equivalent.

Days = gap ÷ max rise per day, rounded up. The default cap is 1 dKH per day; about 1.4 dKH/day is the upper limit. The daily dose is the total grams divided by the number of days.

Cross-check. 1 dKH works out to 0.3566 × 84.007 = 29.96 mg/L of baking soda — about 3.0 g per 100 litres per dKH, the same figure our KH/pH Buffer Calculator uses.

The two buffers differ in their pH effect. Baking soda slightly lowers pH; soda ash raises it. Pick the one that suits your pH, and never mix the two in one dose. Natural seawater sits near 7 dKH; most reefs run 7–11 dKH, and SPS-heavy tanks often aim for 7.5–8.5 dKH.

Worked example

A 100-gallon system (378.5 L) from 7 to 9 dKH with baking soda, at a 1 dKH/day cap.

Inputs

378.5 litres, current 7 dKH, target 9 dKH, baking soda, max rise 1 dKH/day.

Formula

Shortfall = gap × 0.3566 × litres. Baking soda = meq × 84.007 ÷ 1,000. Days = gap ÷ max rise, rounded up.

Calculation

Gap = 9 − 7 = 2 dKH. Shortfall = 2 × 0.3566 × 378.54 = 270.0 meq. Baking soda = 270.0 × 84.007 ÷ 1,000 = 22.68 g. Soda ash instead = 270.0 × 52.995 ÷ 1,000 = 14.31 g. Days = 2 ÷ 1 = 2 days, so 22.68 ÷ 2 = 11.34 g per day. Teaspoons: 22.68 ÷ 4.6 = about 4.9 level teaspoons in total.

Result

22.7 g baking soda, 11.3 g/day over 2 days (or 14.3 g soda ash). One dose a day, retest before the next.

A second case from the same test checks: a 50-gallon system (189.3 L) from 6.5 to 8 dKH needs 101.2 meq, which is 8.5 g baking soda over 2 days at the same 1 dKH/day cap.

How to read your results

The verdict word is the headline: the total grams of the buffer you chose. The stat grid shows the three numbers behind it — the total dose, the dose per day, and the daily rise in dKH with the cap you set.

Read the rows under the verdict for the next step. "Needs action" means do it now — usually the split itself, or dosing alkalinity apart from calcium. "Caution" means respect the limit: the correction is split over days on purpose, and a fast swing stresses SPS corals more than the low reading. "OK" means that check passed — the dose fits inside one safe daily rise, or the handling note is one to follow rather than a warning.

If the verdict says "No dose needed", your alkalinity is already at or above target. Do not dose to push it higher — alkalinity only falls through coral and coralline use and water changes, and an overshoot has to be waited out or diluted.

Common mistakes

  • Using the display volume instead of the net volume. Rock and substrate displace water, so the label gallons overstate the water — measure the system volume with the Tank Volume Calculator first.
  • Spooning the dose. One level teaspoon of baking soda is about 4.6 g, but spoons vary — weigh the dose on a kitchen scale whenever you can.
  • Dosing alkalinity and calcium together. They precipitate as calcium carbonate ("snow") and both readings drop. Dose them hours apart, in different places.
  • Raising alkalinity faster than 1 dKH a day in a stocked tank. A fast swing stresses SPS corals more than the low reading itself — split the correction, even when the single dose looks small.
  • Picking soda ash when pH is already high. Soda ash raises pH; baking soda slightly lowers it. Match the buffer to your pH, not just to the grams.
  • Correcting alkalinity while magnesium is low. Below about 1,250 ppm magnesium, calcium and alkalinity precipitate and the correction will not hold — raise magnesium first.
  • Tipping dry powder straight into the tank. Dissolve each day's dose in RO water first and pour it slowly into the sump or near high flow; soda ash can spike pH locally, so add it more slowly than baking soda.

Grams to raise alkalinity by 1 dKH

Baking soda and soda ash for a 1 dKH rise at each tank size, recomputed with the formula above. Read your size across, then multiply by the gap you need to close.

System volumeBaking sodaSoda ash
25 gal (94.6 L)2.83 g1.79 g
50 gal (189.3 L)5.67 g3.58 g
75 gal (283.9 L)8.50 g5.37 g
100 gal (378.5 L)11.34 g7.15 g
150 gal (567.8 L)17.01 g10.73 g
200 gal (757.1 L)22.68 g14.31 g

Check it against the worked example: 100 gallons needs 11.34 g per dKH, so a 2 dKH rise is 22.68 g — the same 22.7 g the tool gives.

FAQ

Why split the dose over days instead of adding it all at once?

A stocked tank should rise no more than about 1 dKH per day, with about 1.4 dKH/day as the upper limit. A fast alkalinity swing stresses SPS corals more than the low reading itself, so the tool splits the correction at the cap you set and tells you the grams per day.

Baking soda or soda ash — which should I use?

Either closes the same gap; the grams differ because the molar masses differ (22.7 g baking soda against 14.3 g soda ash for the worked example). Choose by pH: baking soda slightly lowers pH, soda ash raises it. Do not mix the two in one dose.

Why grams, not teaspoons?

Teaspoons are approximate — one level teaspoon of baking soda is about 4.6 g, but spoon size and packing vary, and spoon size is where most dosing mistakes start. The gram figure is exact; the spoon figure (about 4.9 teaspoons for the worked example) is only a rough guide. One source lists about 4.7 teaspoons for the same 22.7 g, which implies about 4.7 g per teaspoon — the difference is the spoon, not the chemistry, so weigh the dose when you can.

What if my alkalinity is already at or above target?

Dose nothing. The tool says "No dose needed" and gives no grams. Alkalinity only falls through use and water changes, so an overshoot has to be waited out or diluted — do not chase it down with another chemical.

Does this work for a freshwater tank too?

The grams math is the same — the meq chemistry does not change between fresh and salt water. But the reef targets on this page (7–11 dKH) do not apply to freshwater; use your freshwater target instead, and work out the KH dose in grams with our KH/pH Buffer Calculator, which is built around freshwater KH.

Can I use a commercial buffer instead?

Not with this tool. Commercial buffers differ in strength from brand to brand, and this tool only covers the two dry salts whose doses are stoichiometric. If you use a commercial product, follow its label and the grams it states for your volume.

Sources

  1. Standard — APHA / AWWA / WEF, Standard Methods, Method 2320: Alkalinity. Used for the 0.3566 meq/L per dKH conversion the whole formula rests on.
  2. Textbook — Haynes (ed.), CRC Handbook of Chemistry and Physics. Used for the molar masses: NaHCO3 84.007 g/mol; Na2CO3 105.99 g/mol, 52.995 g per equivalent.
  3. Hobby practice — Holmes-Farley, R., articles on calcium and alkalinity, Reefkeeping Magazine / Advanced Aquarist. Used for the method and the practical limits (about 1 dKH/day, 1.4 dKH/day maximum, dose alkalinity apart from calcium, magnesium first when low).

No links are given here because no source web address was on file for these references — they are named so you can look them up.

Related tools