Reef Dosing Calculator (Alk / Ca / Mg)

Mode
Volume units

Water in the tank, after rock and sand

…in 100 L, from the product label (dKH for alk, ppm for Ca/Mg)

Pace

This tool never guesses a product strength — potency comes from your product's label. Daily rises are capped at the Red Sea Foundation manual's maximums: alkalinity 1.4 dKH/day, calcium 20 ppm/day, magnesium 10 ppm/day. Dose magnesium first, then alkalinity, then calcium, 10 minutes apart.

Your reef dose

Enter your volume, parameter and product potency — the dose in millilitres appears here, either split across days as a correction or as a standing daily dose from two tests.

Why use this calculator?

  • Hold parameters steady instead of chasing them — the consumption mode turns two tests into a standing daily dose.
  • Corrections split safely — a big gap is spread over enough days to stay inside the daily limits.
  • No precipitation from one big dose — no dumping a week's worth of alkalinity in at once.
  • Works with any brand, because the potency comes from the label you hold.

Check your salt mix with the Salinity Converter, your tank size with the Tank Volume Calculator, and the rest of the water with the Water Parameter Checker. · Back to Saltwater & Reef

Enter your net volume, a test reading and the product potency from its label, and get the dose in millilitres — split over enough days to stay inside the safe daily rise, or a standing daily dose from two tests. Everything runs in your browser; nothing is saved.

How it works

This tool has two modes. Correction mode raises a low reading to a target. Consumption mode measures how much your tank uses each day, from two tests, and turns that into a standing daily dose.

Potency is never guessed. Every product states its strength on the label as "1 mL raises X in 100 litres" — in dKH for an alkalinity product, in ppm for a calcium or magnesium product. Enter that number; the tool does the rest.

Correction — total dose (mL) = gap ÷ potency × (litres ÷ 100). The gap is your target minus your current reading. A bigger tank, a bigger gap, or a weaker product all raise the total.

Correction — days = gap ÷ daily limit, rounded up. The daily limits are the Red Sea Foundation manual's maximums: alkalinity 1.4 dKH/day, calcium 20 ppm/day, magnesium 10 ppm/day. The alkalinity limit is 0.5 meq/L per day, which is 0.5 ÷ 0.3566 = 1.4 dKH/day. The dose per day is the total millilitres divided by the number of days.

Gentle pace is half pace. Alkalinity 0.5 dKH/day — the SPS pace reef keepers cite as "under 1 dKH a day, ideally 0.3 to 0.5" — and calcium and magnesium at half their Red Sea maximums, 10 and 5 ppm/day.

Consumption — daily use = fall ÷ days between tests. Test, wait, test again with no dosing in between — Red Sea's own consumption test runs 4 days. The fall between the two readings, divided by the days, is what the tank uses each day.

Consumption — standing dose (mL/day) = daily use ÷ potency × (litres ÷ 100). That dose replaces what the tank uses each day. The weekly dose is seven times the daily dose.

Dose order matters. Magnesium first, then alkalinity, then calcium, 10 minutes apart — the reverse order can precipitate calcium carbonate and drop alkalinity.

Worked example

Correction first: a 300-litre tank, alkalinity 7.2 to 8.0 dKH, product potency 0.1 dKH per mL per 100 litres, standard pace.

Inputs

300 litres, alkalinity 7.2 → 8.0 dKH, potency 0.1 dKH per mL per 100 L, standard pace.

Formula

Total mL = gap ÷ potency × (litres ÷ 100). Days = gap ÷ daily limit, rounded up. mL/day = total ÷ days.

Calculation

Gap = 8.0 − 7.2 = 0.8 dKH. Total = 0.8 ÷ 0.1 × (300 ÷ 100) = 24.0 mL. Days = 0.8 ÷ 1.4 = 1 day (rounded up). So 24.0 mL/day for 1 day. At gentle pace the limit is 0.5 dKH/day, so days = 0.8 ÷ 0.5 = 2 days at 12.0 mL/day.

Result

24.0 mL total — 24.0 mL/day for 1 day (or 12.0 mL/day over 2 days gentle). Retest before dosing anything else.

Consumption next: the same kind of tank, 200 litres, alkalinity 8.0 to 7.6 dKH over 4 days, potency 0.1. Daily use = (8.0 − 7.6) ÷ 4 = 0.10 dKH/day. Standing dose = 0.10 ÷ 0.1 × (200 ÷ 100) = 2.0 mL/day, about 14 mL per week.

Two more cases from the test checks, one per element. Calcium: 200 litres, 380 to 420 ppm, potency 2 ppm per mL per 100 litres — total = 40 ÷ 2 × 2 = 40 mL over 2 days at 20 mL/day, inside the 20 ppm/day limit. Magnesium: 100 litres, 1,200 to 1,300 ppm, potency 1 ppm per mL per 100 litres — total = 100 ÷ 1 × 1 = 100 mL over 10 days at 10 mL/day, inside the 10 ppm/day limit.

How to read your results

In correction mode the verdict word is the total millilitres, and the stat grid shows the total dose, the dose per day, and the daily limit the split stayed inside. In consumption mode the verdict word is the standing dose in millilitres per day, and the stat grid shows the daily use, the standing dose, and the weekly dose.

Read the rows under the verdict for the next step. "Needs action" means do it now — usually the split itself, or the dose order. "Caution" means respect the limit: the correction is split over days on purpose, and raising a parameter faster than its daily limit stresses corals more than the low reading. "OK" means that check passed — the dose fits inside one safe daily rise, or the handling note is one to follow rather than a warning.

If the verdict says "No dose needed", the reading is already at or above target — do not dose to push it higher. If consumption mode says "No consumption measured", the reading did not fall between the two tests: there is no standing dose to calculate, so retest and check the test kit before dosing anything.

Common mistakes

  • Guessing the potency. Every product states it on the label as "1 mL raises X in 100 litres" — a guessed potency gives a wrong dose in direct proportion. If the label does not state it, do not use this tool for that product.
  • Dosing between the two consumption tests. Any dose in between makes the fall look smaller than the real use, and the standing dose comes out too low. No dosing, and no water change, between the two tests.
  • Testing at different times of day. Alkalinity and calcium drift through the day as corals photosynthesise — test at the same time of day for both readings, at least 3 days apart.
  • Dosing alkalinity and calcium together, or in the wrong order. Dose magnesium first, then alkalinity, then calcium, 10 minutes apart — the reverse order can precipitate calcium carbonate and crash alkalinity.
  • Dumping a week's worth of alkalinity in at once. A big one-off dose precipitates and drops both readings; the tool splits it across days for a reason.
  • Chasing a single number instead of holding steady. Typical reef targets are roughly 7–11 dKH alkalinity, 380–450 ppm calcium and 1,250–1,500 ppm magnesium — steady inside the range matters more than any single reading.
  • Never re-running the consumption test. Demand rises as corals grow, so re-measure every few weeks and after any big change in coral stock.

Daily limits and typical reef targets

The Red Sea daily maximums this tool splits corrections inside, the gentle pace, and the typical reef ranges the results are judged against. All figures from the sources below — none are guessed.

ParameterStandard max / dayGentle / dayTypical reef range
Alkalinity1.4 dKH0.5 dKH7–11 dKH
Calcium20 ppm10 ppm380–450 ppm
Magnesium10 ppm5 ppm1,250–1,500 ppm

Check it against the worked examples: the alkalinity correction fits inside 1.4 dKH/day in 1 day, the calcium correction inside 20 ppm/day in 2 days, and the magnesium correction inside 10 ppm/day in 10 days.

FAQ

Where do I find the product potency?

On the product label, stated as "1 mL raises X in 100 litres" — in dKH for an alkalinity product, in ppm for a calcium or magnesium product. This tool never guesses a product strength: if the label does not state it, do not use this tool for that product.

Why is the magnesium limit 10 ppm a day here, but 100 in the Magnesium Calculator?

The two tools use different sources, and the disagreement is stated, not hidden. This tool uses the Red Sea Foundation manual's 10 ppm/day maximum. The Reef Magnesium Calculator defaults to 100 ppm/day, in line with Holmes-Farley's DIY magnesium guidance — and its max-rise box can be set to 10 for the much slower correction this tool uses. On a stocked reef, use the gentler figure.

What is the gentle pace for?

Half pace: alkalinity 0.5 dKH/day, calcium 10 ppm/day, magnesium 5 ppm/day. The alkalinity figure is the SPS pace reef keepers cite — "under 1 dKH a day, ideally 0.3 to 0.5". Use it on an SPS-heavy tank, or whenever a correction is large and the livestock is sensitive.

Why dose magnesium first?

Magnesium holds calcium and alkalinity in solution. Dose magnesium first, then alkalinity, then calcium, 10 minutes apart. Dosing calcium into a tank whose magnesium is low can precipitate calcium carbonate and crash alkalinity.

How often should I re-run the consumption test?

Every few weeks, and after any big change in coral stock — demand rises as corals grow, so a standing dose set months ago drifts low. Test at the same time of day, at least 3 days apart, with no dosing and no water change in between.

What if the second test is higher than the first?

Then no consumption was measured: the reading rose instead of falling. The tool says "No consumption measured" and gives no dose. Retest, and check the test kit — a rising reading usually means a test error, a recent water change, or a dose you forgot about.

Sources

  1. Manufacturer — Red Sea Reef Care Program, Foundation manual (v21a). Used for the daily maximums (alkalinity 0.5 meq/L = 1.4 dKH/day, calcium 20 ppm/day, magnesium 10 ppm/day), the dose order (magnesium, then alkalinity, then calcium, 10 minutes apart), and the 4-day consumption test with no dosing in between.
  2. Standard — APHA / AWWA / WEF, Standard Methods, Method 2320: Alkalinity. Used for the 0.3566 meq/L per dKH conversion behind the 0.5 meq/L = 1.4 dKH/day alkalinity limit.
  3. Hobby practice — reef.cameronshields.co.uk. Used for the gentle alkalinity pace ("under 1 dKH a day, ideally 0.3 to 0.5") and for the worked correction example (0.8 dKH gap in 300 litres at 0.1 dKH per mL per 100 litres = 24 mL).

No links are given here because no source web address was on file for these references — they are named so you can look them up. One correction is stated plainly here too: an early draft of this tool used 100 ppm/day for magnesium. That is wrong — Red Sea's limit is 10 ppm/day, and this tool uses 10.

Related tools