African Cichlid Buffer Calculator

Buffer the new water, not the tank

Mix this recipe into each batch of water-change water, sized to that batch. Buffering the tank directly makes it easy to overshoot. For an already-set-up tank, raise KH by no more than 1–2 dKH per day.

The water-change batch, not the whole tank
1 US gallon = 3.785 litres
Tap or RO — 0 for pure RO water
Tap or RO — 0 for pure RO water
Keeping targets run a little harder than the lakes themselves
Optional — 0 leaves it out. Reef/marine salt mix, never table salt
25% for Tanganyika — soda ash settles at a higher pH than baking soda

Dissolve in order — Epsom + marine salt first, then baking soda, soda ash last — and test pH, GH and KH the next day. Chemistry: 1 dGH = 0.1783 mmol/L, 1 dKH = 0.3566 mmol/L (DIN 38409); carbonate carries two units of alkalinity per mole, so soda ash needs half the moles of baking soda for the same KH.

Your recipe

Enter the water to prepare, its GH and KH, and a lake target — the recipe appears here, with the weighed salts for exactly that batch.

Why use this calculator?

  • Turn a lake target into weighed grams for exactly the batch of water you are preparing — no guessing from spoonfuls.
  • See the marine salt's GH contribution before the Epsom salt is worked out, so the GH is not double-counted.
  • Pick Malawi, Tanganyika or Victoria, or set a custom GH/KH target for a mixed or species tank.
  • Get spoon figures where they are safe (baking soda, Epsom, marine salt) and a weigh-it warning for soda ash.
  • Catch the cases where your tap water already meets a target — the dose is zero, not negative.

Dissolve in order — Epsom + marine salt first, then baking soda, soda ash last — and test pH, GH and KH the next day. To fine-tune KH on its own, use the KH/pH Buffer Calculator; to check the finished water, use the Water Parameter Checker. · Back to Water Chemistry

Mix a batch of water-change water to Rift Lake hardness, with DIY salts weighed in grams. Pick Lake Malawi, Tanganyika or Victoria — or set a custom GH/KH target — and get the recipe for exactly the batch you are preparing. For example, 50 gallons of tap water at GH 4 / KH 3 made into Malawi water needs 30 g of marine salt, 19.9 g of Epsom salt and 39.7 g of baking soda. Buffer the new water, not the tank. Everything runs in your browser; nothing is saved.

How it works

The degrees are standard. 1 dGH = 0.1783 mmol/L of calcium plus magnesium; 1 dKH = 0.3566 mmol/L of bicarbonate (DIN 38409). The molar masses come from the CRC Handbook: baking soda (NaHCO3) 84.007, soda ash (Na2CO3) 105.99, Epsom salt (MgSO4·7H2O) 246.47 g/mol.

Marine salt first, because it adds GH. Full-strength seawater (35 g/L) is about 355 dGH from its calcium (about 412 mg/L) and magnesium (about 1,290 mg/L) — Millero, Chemical Oceanography — so the salt's GH is 355 × (salt g/L ÷ 35). At 1 teaspoon per 10 gallons the salt adds about 1.6 dGH, and the Epsom salt is worked out after it, so the GH is never double-counted.

The formulas. Marine salt in grams = teaspoons per 10 gal × (gallons ÷ 10) × 6.0. Epsom salt = (target GH − source GH − salt GH) × 0.1783 × litres × 246.47 ÷ 1,000. Baking soda = KH gap × (1 − soda-ash share) × 0.3566 × litres × 84.007 ÷ 1,000. Soda ash = KH gap × soda-ash share × 0.1783 × litres × 105.99 ÷ 1,000. Carbonate carries two units of alkalinity per mole, so soda ash needs half the moles of baking soda for the same KH. A gap already met gives 0 g for that ingredient — never a negative dose.

Dissolve in order, then test. Epsom salt and marine salt first, then baking soda, soda ash last. Mix for an hour with a pump or air stone, test pH, GH and KH the next day, and only then use the water. For an already-set-up tank, raise KH by no more than 1–2 dKH per day.

The lake targets. Malawi GH 8 / KH 10, pH 7.8–8.6; Tanganyika GH 12 / KH 15, pH 8.6–9.2 (25% of the KH from soda ash); Victoria GH 6 / KH 8, pH 7.5–8.5 (Bootsma & Hecky 2003). Keeping targets run a little harder than the lakes themselves, for more buffer between water changes.

Worked example

50 US gallons of tap water at GH 4 / KH 3, made into Malawi water at GH 8 / KH 10, with 1 teaspoon of marine salt per 10 gallons.

Inputs

Volume 50 US gal (189.3 L), source GH 4 / KH 3, target GH 8 / KH 10 (Lake Malawi), marine salt 1 tsp per 10 gal, no soda ash.

Formula

Salt = tsp per 10 gal × (gal ÷ 10) × 6.0 g. Salt GH = 355 × (salt g/L ÷ 35). Epsom = GH gap × 0.1783 × litres × 246.47 ÷ 1,000. Baking soda = KH gap × 0.3566 × litres × 84.007 ÷ 1,000.

Calculation

Salt = 1 × 5 × 6.0 = 30 g, which is 0.159 g/L, so +1.6 dGH. Epsom = (8 − 4 − 1.6) × 0.1783 × 189.27 = 19.9 g. Baking soda = 7 × 0.3566 × 189.27 = 39.7 g.

Result

30 g marine salt, 19.9 g Epsom salt and 39.7 g baking soda — GH 8.0, KH 10.0. Total 89.6 g of salts for the 50-gallon batch.

The same water as Tanganyika water (GH 12 / KH 15, 25% of the KH from soda ash) needs 51.0 g of baking soda, 10.7 g of soda ash, 53.2 g of Epsom salt and the same 30 g of marine salt — 144.9 g in total.

How to read your results

The verdict word is the total grams of salts for the batch. Under it, the pair line shows the volume and the GH and KH the water will reach.

The stat grid shows the three numbers that decide the recipe: the resulting GH, the resulting KH, and the marine salt's GH contribution (counted before the Epsom salt, so you can see it is not double-counted). Below the stats, the recipe table lists each salt, its weighed grams (with level teaspoons where they are safe), and what it does. Below the table, the checks are grouped. "Caution" is a risk — read it before you start. "OK" means that check passed.

Watch for the already-met rows: if your tap water already meets a target, that ingredient is 0 g, not negative — hard alkaline tap water above about GH 8 / KH 10 often suits Malawi cichlids as it is, with marine salt only. What to do next: dissolve in order, mix for an hour, test pH, GH and KH the next day, and only then use the water. If pH is low but KH is right, the tank needs more surface movement, not more buffer.

Common mistakes

  • Buffering the tank directly. Mix the recipe into each batch of water-change water, sized to that batch — buffering the tank makes it easy to overshoot.
  • Adding dry powder to a stocked tank. Dissolve in order, mix for an hour, test the next day.
  • Using table salt or aquarium tonic salt instead of a reef/marine salt mix. Marine salt is a reef/marine salt mix, never table salt — and it is optional: enter 0 to leave it out.
  • Forgetting the marine salt adds GH. At 1 teaspoon per 10 gallons it adds about 1.6 dGH — the tool counts it before working out the Epsom salt, so do not add Epsom for that GH twice.
  • Using too much soda ash. It is a stronger base than baking soda: the same KH rise settles at a higher pH. Start with 25% of the KH from soda ash, as the Tanganyika preset does, and test pH the next day.
  • Raising KH too fast in a set-up tank. No more than 1–2 dKH per day — buffer the new water, not the tank.
  • Weighing soda ash by the spoon. Spoon figures are given for baking soda (4.8 g), Epsom salt (5.0 g) and marine salt (6.0 g) per level teaspoon — soda ash has no spoon figure; weigh it always.
  • Buffering water that does not need it. If your tap water already meets a target, that dose is zero — check the result before adding anything.

Recipes per 10 US gallons

Each recipe uses 1 teaspoon of marine salt per 10 gallons. Tap water is GH 4 / KH 3; RO water is 0 / 0. Teaspoons are rounded to the nearest quarter-teaspoon and are approximate — weigh the dose when you can, and weigh soda ash always.

Recipe (per 10 US gal)Baking sodaSoda ashEpsom salt
Malawi from tap (GH 4 / KH 3 → 8 / 10)7.9 g (1¾ tsp)—4.0 g (¾ tsp)
Malawi from RO (0 / 0 → 8 / 10)11.3 g (2¼ tsp)—10.6 g (2¼ tsp)
Tanganyika from RO (0 / 0 → 12 / 15, 25% ash)12.8 g (2¾ tsp)2.7 g (weigh it)17.3 g (3½ tsp)
Victoria from RO (0 / 0 → 6 / 8)9.1 g (2 tsp)—7.3 g (1½ tsp)

The Rift Lakes at a glance

Keeping targets run a little harder than the lakes themselves, for more buffer between water changes.

LakepHGH / KHNotes
Malawi7.8–8.68 / 10Mbuna, peacocks, haps — moderately alkaline, very stable
Tanganyika8.6–9.212 / 15Shell dwellers, Tropheus — most alkaline, magnesium-rich
Victoria7.5–8.56 / 8Haplochromines — softer than the other two lakes

FAQ

What is the DIY recipe?

Marine salt, Epsom salt, baking soda, and soda ash for Tanganyika — weighed in grams for the batch of water you are preparing. The tool works out each one: marine salt first (it adds a little GH), Epsom salt makes up the rest of the GH as magnesium, baking soda (plus soda ash for Tanganyika) makes up the KH. The worked example and the per-10-gallon table above give the full recipe.

Why Epsom salt and not calcium?

Rift Lake water is unusually magnesium-rich compared with calcium, so magnesium sulphate is the closer match — and it dissolves instantly. The marine salt adds some calcium plus strontium, potassium and other trace elements.

What does soda ash do?

Soda ash (sodium carbonate, sold as washing soda) is a stronger base than baking soda: replacing part of the baking soda raises KH by the same amount but settles at a higher pH. That suits Tanganyikan cichlids at pH 8.6–9.2. Start with 25% of the KH from soda ash, as the Tanganyika preset does, and test pH the next day. Weigh it — there is no spoon figure for it.

Can I add buffer straight to the tank?

No — mix the recipe into each batch of water-change water, sized to that batch. Buffering the tank directly makes it easy to overshoot. For an already-set-up tank, raise KH by no more than 1–2 dKH per day.

Do I need marine salt?

It is optional. At 1 teaspoon per 10 US gallons it adds trace elements and about 1.6 dGH — not enough to make the water brackish. The recipe works without it; the Epsom salt then carries the whole GH rise. If you add it, use a reef/marine salt mix, never table salt or aquarium tonic salt.

My tap water is already hard — do I need any of this?

Often not. Hard alkaline tap water above about GH 8 / KH 10 suits Malawi cichlids as it is, with marine salt only. Enter your tap GH and KH and the tool shows which ingredients are zero — a dose already met is 0 g, never negative.

Sources

  1. Textbook — Millero, F. J., Chemical Oceanography, CRC Press. Major-ion composition of seawater at 35 g/kg: calcium about 412 mg/L, magnesium about 1,290 mg/L, about 355 dGH. Used for the marine salt's GH contribution.
  2. Peer-reviewed — Bootsma, H. A. and Hecky, R. E. (2003). A comparative introduction to the biology and limnology of the African Great Lakes. Journal of Great Lakes Research 29 (Suppl. 2). Water chemistry of Lakes Malawi, Tanganyika and Victoria.
  3. Standard — DIN 38409. 1 dGH = 0.1783 mmol/L Ca + Mg; 1 dKH = 0.3566 mmol/L bicarbonate.
  4. Textbook — Haynes (ed.), CRC Handbook of Chemistry and Physics. Molar masses: sodium bicarbonate 84.007, sodium carbonate 105.99, magnesium sulphate heptahydrate 246.47; carbonate carries two equivalents of alkalinity per mole.

Related tools