Water Chemistry

Water chemistry is the set of readings that decide whether your fish are comfortable or stressed: pH and hardness, the ammonia your kit actually measures, and the oxygen the water can hold. This hub gathers the calculators that turn those readings into decisions — how much baking soda lifts KH, how much RO water softens a batch, how big a water change cuts nitrate, and whether a total ammonia reading is an emergency or a false alarm. Each tool works out one job from your own numbers, in your browser, with nothing saved.

Use it when a test kit gives you a number and you need to know what to do with it — before a water change, while cycling a new tank, or when a reading looks wrong.

Find your calculator

pH, KH & GH

  • pH Calculator — Works out the KH change a pH move needs at the same CO₂, and the baking-soda or acid-buffer dose to get there, split over days so the shift stays gentle.
  • KH/pH Buffer — Works out the weighed baking-soda dose that lifts KH by the amount you need, split across days at no more than 1 dKH a day in a stocked tank.
  • GH/KH Remineralisation — Works out the grams of remineraliser — Salty Shrimp label dose or your own DIY salts — that bring RO water to your target GH and KH, with the Ca:Mg ratio and TDS rise shown before the water goes in.
  • African Cichlid Buffer — Works out the weighed salts to mix a batch of water-change water to Rift Lake hardness — Malawi, Tanganyika or Victoria targets, or your own.

Water prep

  • RO Water Mixing — Works out the exact tap-to-RO split for a batch of water so it lands on your target hardness.
  • Water Change Calculator — Shows the nitrate left after a water change, and how big a change you need to reach your target.
  • Dechlorinator Dosing — Works out the dechlorinator dose for a water change in millilitres, drops or cap threads, from the label dose on your bottle.
  • Salt Treatment — Works out the aquarium salt for a treatment level in tablespoons, grams and teaspoons, with the species warnings shown before you dose.

Units, toxicity & checks

  • Hardness Converter — Converts a hardness reading between dGH, dKH, ppm as CaCO₃, meq/L, mmol/L, grains per gallon, French degrees and Clark degrees, and shows all eight at once with the USGS band.
  • TDS to Conductivity — Converts between TDS in ppm and conductivity in µS/cm and mS/cm, in both directions, with the NaCl 0.50, 442 0.70 or your own factor.
  • Nutrient Units — Converts nitrate, nitrite, phosphate and ammonia readings between the ion form and the as-nitrogen / as-phosphorus form, and between ppm and ppb, so kit readings can be compared against any guide.
  • Free Ammonia — Works out how much of a total ammonia reading is the toxic free ammonia, from pH and temperature, and whether it is an emergency.
  • Ammonia Dosing — Works out the ammonia dose for a fishless cycle in millilitres or drops, and what to test next.
  • Dissolved Oxygen — Works out the maximum oxygen your water can hold at your temperature, salinity and altitude, and turns a meter reading into percent saturation.
  • Water Checker — Checks a set of test-kit readings against the site's own targets and says what to do next.
  • Cycle Tracker — Logs each cycle test — ammonia, nitrite, nitrate — and shows the cycle moving from ammonia phase to nitrite phase to cycled.
  • Shrimp Checker — Checks pH, GH, KH, TDS and temperature against keeper ranges and shows which shrimp species the water suits, naming the parameter that is off when it does not.

See the other hubs: Tank Size & Setup · Saltwater & Reef · Planted Tank · Stocking & Fish Care · See all 88 tools.