Lower Salinity Calculator

Actual water, after rock and sand — not the tank's rated size

Hyposalinity target is 1.008–1.010

Tank type

Worked example: a 50 gal fish-only system going from SG 1.024 to 1.009 at 0.005/day swaps 10.39 gal on day 1, 13.15 gal on day 2 and 17.87 gal on day 3, holds for 4 weeks, then takes 15 days to come back up at 0.001/day. The swap share is 1 − S₂÷S₁, with SG converted to salinity by the EOS-80 equation of state (Millero & Poisson 1981).

How much water to move?

Enter your volume and salinities — the gallons to swap or top up appear here, or the full day-by-day hyposalinity plan.

Why use this calculator?

  • Get the exact gallons to swap or top up — no guessing, and no overshooting a small adjustment.
  • A day-by-day hyposalinity schedule with each day's swap volume, hold time and return time.
  • Works in gallons or litres, and for a one-off adjustment or a full plan.
  • Warns you before a plan that would harm a reef tank — hyposalinity is fish-only.
Hyposalinity is fish-only — and this tool is math only

It kills corals, invertebrates and live rock/sand life, so it belongs in a separate quarantine tank, never in a reef display. The plan lowers salinity; it does not diagnose anything and it is not a cure. If fish look sick, ask a vet or an experienced keeper with the full test results in hand.

Check a hydrometer reading first with the Hydrometer Temperature Correction Calculator, or convert units with the Salinity Converter. · Back to Saltwater & Reef

Work out exactly how much fresh water to swap or top up to reach a lower salinity — or get a day-by-day hyposalinity plan with each day's swap volume, hold time and return time. Hyposalinity is fish-only and this tool is math only — it does not diagnose anything and it is not a cure. Everything runs in your browser; nothing is saved.

How it works

All three modes are salt-mass balance: salt is neither created nor destroyed, it is only diluted. SG is first converted to salinity in ppt with the EOS-80 equation of state at 25 °C (Millero & Poisson 1981) — the same physics as the Salinity Converter.

One swap. Replacing a share r of the water with fresh RO/DI water leaves salinity S × (1 − r), so the swap share is r = 1 − S₂ ÷ S₁ and the gallons to replace are V × r.

Top up. Adding F gallons of fresh water to V gallons leaves S × V ÷ (V + F), so the top-up is F = V × (S₁ ÷ S₂ − 1). A top-up always takes more water than a swap for the same drop, because the fresh water stays in the tank and dilutes the salt instead of removing it.

Hyposalinity plan. The tool steps down by a fixed SG increment per day: SGₙ = max(target, start − n × step), and that day's swap is V × (1 − Sₙ ÷ Sₙ₋₁). Each day's swap grows as the water gets fresher, because each step removes the same SG but a bigger share of what is left. The hold is counted from the day the target is reached, and the return is the SG gap divided by the return rate.

Hyposalinity context. Full hyposalinity is SG 1.009 (about 12 ppt), held 4–6 weeks (Univ. of Florida IFAS Extension FA164, Yanong, on Cryptocaryon irritans). It is fish-only: corals, invertebrates, live rock and live sand life do not survive it, so this tool refuses to build a hyposalinity plan for a reef tank.

Worked example

A fish-only 50-gallon system going from SG 1.024 to SG 1.009, stepping down 0.005 SG per day, holding 4 weeks, and coming back up at 0.001 SG per day.

Inputs

50 gal, fish-only, SG 1.024 → 1.009, step 0.005/day, hold 4 weeks, return 0.001/day.

Formula

SG → ppt by EOS-80 at 25 °C. Each day's swap = V × (1 − Sₙ ÷ Sₙ₋₁). Days back up = (start − target) ÷ return rate.

Calculation

SG → ppt: 1.024 = 31.87, 1.019 = 25.25, 1.014 = 18.61, 1.009 = 11.96. Day 1: 50 × (1 − 25.25 ÷ 31.87) = 10.39 gal to SG 1.019. Day 2: 50 × (1 − 18.61 ÷ 25.25) = 13.15 gal to SG 1.014. Day 3: 50 × (1 − 11.96 ÷ 18.61) = 17.87 gal to SG 1.009. Return: (1.024 − 1.009) ÷ 0.001 = 15 days.

Result

3 days down (10.39, 13.15 and 17.87 gal), 4 weeks hold at SG 1.009, 15 days back up. The swaps grow each day even though the SG step stays the same.

A second case, a small adjustment with no plan: a 50-gallon reef tank going from SG 1.026 to 1.024 needs 3.83 gal swapped (7.7% of the water) or 4.14 gal topped up. The top-up is bigger, because the added fresh water stays in the tank.

How to read your results

The verdict word is the headline, and the stat grid shows the three numbers behind it. For a swap or top-up: the gallons to swap out, the gallons to top up instead, and the salinity change in ppt. For a hyposalinity plan: the days down, the weeks of hold, and the days back up — with the day-by-day schedule table underneath.

Swap water and Top up fresh water are the two ways to make the same one-off adjustment; the swap removes water and replaces it, the top-up only adds water and takes more of it. Hyposalinity plan is the full schedule: each day's SG after the swap and each day's fresh water to swap in.

No plan for a reef tank means you asked for a hyposalinity plan on a reef tank — the tool refuses, because hyposalinity kills corals, invertebrates and live rock/sand life. It still gives the one-swap number for a small adjustment, and the fix is to move the fish to a separate fish-only quarantine tank.

Read the rows under the verdict for the warnings: a target below SG 1.008, steps above 0.005 SG/day, and the reminders to test ammonia and nitrite daily while salinity is low. "Needs action" means the plan was refused — do not run it. "Caution" means slow down or rethink the target. "OK" means that check passed.

Common mistakes

  • Dropping the salinity too fast. Fish tolerate 0.003–0.005 SG per day on the way down — faster steps stress them, and the return trip is slower still, at 0.001 SG per day.
  • Counting the hold from the wrong day. The hold starts the day the target is reached, not the day the plan starts — a 4-week hold after a 3-day step-down is 31 days in total.
  • Running hyposalinity in a reef display. It kills corals, invertebrates and live rock/sand life — it belongs in a separate quarantine tank, never in the display.
  • Going below SG 1.008. Hyposalinity targets are 1.008–1.010; below 1.008 the fish are in danger, not the parasite.
  • Using the tank's rated size as the volume. Rock and sand displace water — use the actual water volume, not the label on the glass, or every swap is oversized.
  • Measuring with a swing-arm hydrometer at SG 1.009. At that level a small reading error is a big share of the target — use a calibrated refractometer, and test ammonia and nitrite daily, because the biofilter suffers at low salinity.

Swap and top-up for 50 gallons

Gallons of fresh RO/DI water to swap out, or to top up with, for a 50-gallon system at each SG change. All figures recomputed with this tool's EOS-80 code.

FromToSwap shareSwapTop up
1.0271.0263.7%1.84 gal1.91 gal
1.0261.0253.8%1.91 gal1.99 gal
1.0261.0247.7%3.83 gal4.14 gal
1.0281.02510.7%5.33 gal5.96 gal
1.0301.02613.2%6.62 gal7.64 gal

The top-up is always bigger than the swap for the same change, and the gap grows with the size of the change — for a 1.030 to 1.026 drop the top-up is a full gallon more than the swap. For other volumes, scale in proportion: a 100-gallon system needs twice these gallons, a 25-gallon system half.

FAQ

Why does each day's swap get bigger in a hyposalinity plan?

Because each step removes the same SG but a bigger share of what is left. Day 1 drops SG 1.024 to 1.019 — 31.87 to 25.25 ppt, a 20.8% share, or 10.39 gallons of a 50-gallon system. Day 3 drops 1.014 to 1.009 — 18.61 to 11.96 ppt, a 35.7% share, or 17.87 gallons. Same 0.005 SG step, much bigger swap.

How long do I hold at SG 1.009?

The tool defaults to 4 weeks, counted from the day the target is reached. UF/IFAS guidance (FA164) puts the hold at 4–6 weeks at SG 1.008–1.010 — above 1.010 the parasite survives, below 1.008 the fish are stressed. The hold is editable in the form, and the return trip takes 15 days at 0.001 SG per day.

Can I use hyposalinity in a reef tank?

No. It kills corals, invertebrates and live rock/sand life, so this tool refuses to build a hyposalinity plan for a reef tank. Move the fish to a separate fish-only quarantine tank first. For a small adjustment in a reef tank — say 1.026 to 1.024 — use the one-swap mode instead, and keep each day's drop at or under 0.002 SG.

Swap or top-up — which should I choose?

A swap is the precise option: it removes water and replaces it, so the volume stays the same and the maths is exact. A top-up only adds fresh water, so it takes more water for the same drop and raises the water level. Use a swap when the tank has room to drain, a top-up when it does not — and never top up past the rim.

Does this tool cure sick fish?

No. It is math only: it lowers salinity, it does not diagnose anything and it is not a cure. If fish look sick, ask a vet or an experienced keeper with the full test results in hand — and leave the display tank fishless for at least 6 weeks if parasites were the reason for the move.

Why test ammonia and nitrite while salinity is low?

Because the biofilter suffers at low salinity, so ammonia and nitrite can spike while the fish are already stressed by the change. Test daily through the step-down and the hold, and be ready with a water change if either reads above zero.

Sources

  1. Government — Yanong, R. P. E., Univ. of Florida IFAS Extension FA164. Cryptocaryon irritans Infections (Marine White Spot Disease) in Fish. Used for hyposalinity at SG 1.009 (about 12 ppt), held 4–6 weeks, and for the fish-only rule.
  2. Peer-reviewed — Millero & Poisson (1981). International one-atmosphere equation of state of seawater. Deep-Sea Research 28A: 625–629. Used for the EOS-80 densities behind the SG-to-ppt conversion (1.024 = 31.87 ppt, 1.009 = 11.96 ppt).
  3. Method — salt mass balance. Replacing share r lowers salinity to S × (1 − r); adding F gallons lowers it to S × V ÷ (V + F). The method is the tool's own arithmetic, checked against the worked examples in the test file.

These sources are listed by name; no web link was on file for them.

Related tools