Saltwater Mix Calculator

Volume units

1.000 for fresh RO/DI water

Reef target: 1.024–1.026

Grams of mix = litres × change in ppt, where the ppt values come from the EOS-80 equation of state at 25°C — the same physics as the Salinity Converter. Cups are rough (about 1 cup ≈ 270 g); weigh the mix when you can.

How much salt mix?

Enter your water volume and salinities — the grams of salt mix to add appears here, with kilograms and rough cups.

Why use this calculator?

  • Mix it right the first time — no wasted saltwater from overshooting.
  • Safe salinity for livestock, aimed at the reef range 1.024–1.026.
  • Works from fresh RO/DI or from a tank that is already part-way there.
  • Grams, kilograms and rough cups together, so any scale or scoop works.

Convert between salinity units with the Salinity Converter, or check the water itself with the Water Parameter Checker. · Back to Saltwater & Reef

Enter your water volume and the salinity you are starting from and aiming for, and get the grams of salt mix to add. Mix it right the first time — no wasted saltwater, and a safe salinity for livestock. Everything runs in your browser; nothing is saved.

How it works

The tool works out how much saltier the water needs to get, then multiplies by how much water there is. Both salinities are converted to ppt with the EOS-80 equation of state at 25 °C (Millero & Poisson 1981) — the same physics as the Salinity Converter — so SG 1.025 is 33.2 ppt, not 35 ppt.

Grams of salt mix = litres of water × change in ppt. The change in ppt is the target salinity minus the current salinity, both in ppt. One litre of water takes about one gram of mix per ppt — that is the whole formula, with no salt factor added.

Litres from gallons. 1 US gallon = 3.78541 litres. A 20-gallon batch is 75.71 litres, so the same formula works in either unit.

Cups are rough. About 1 cup of dry mix is taken as roughly 270 g, from the common label direction of about half a cup per US gallon. Brands and grain sizes vary, so cups are a scoop estimate — weigh the mix when you can.

The reef target. The site's own water target for reef tanks is SG 1.024–1.026 (about 32–35 ppt). A target below that is fine for a fish-only setup and low for corals; a target above it deserves a double-check before mixing.

Worked example

Mixing 100 litres of fresh RO/DI water up to SG 1.025.

Inputs

100 litres of RO/DI water, current SG 1.000, target SG 1.025.

Formula

Grams = litres × change in ppt. SG 1.025 = 33.19 ppt and SG 1.000 = 0 ppt by EOS-80 at 25 °C. Cups = grams ÷ 270.

Calculation

Change in ppt = 33.19 − 0 = 33.19 ppt. Grams = 100 × 33.19 = 3,318.8 g, or 3.32 kg. Cups = 3,318.8 ÷ 270 = 12.3 cups (rough — weigh it if you can).

Result

3,319 g of salt mix (3.32 kg, about 12.3 cups) for 100 litres, taking SG 1.000 to SG 1.025 — inside the reef range.

The same formula on smaller batches: 20 gallons (75.71 litres) of RO/DI to SG 1.025 takes 2,513 g. Topping up 10 litres from SG 1.020 to 1.025 takes only 66 g (the change is 6.62 ppt, not the full 33.19). And 200 litres to SG 1.026 takes 6,902 g.

How to read your results

The verdict word is the headline, and the stat grid shows the three numbers behind it: the grams of salt mix, the rough cups, and the salinity to add in ppt.

Add salt mix means the tool has a number for you — check the target row to see whether it sits inside the reef range. No salt needed means the water is already at or above the target SG, and adding mix would overshoot it.

The rows under the verdict say whether the target is inside the reef range 1.024–1.026, and remind you to mix in a separate container and verify with a refractometer. "Caution" means check the target before mixing; "OK" means that check passed. The grams are an estimate — brand mix rates vary, and the finished water is what counts.

Common mistakes

  • Adding water onto dry salt. Add salt to moving RO/DI water, never water onto salt — dry salt clumps and dissolves unevenly.
  • Testing too soon. Wait until the batch is clear and at temperature before testing — readings drift for about an hour after mixing.
  • Trusting cups. One cup is roughly 270 g, but brands and grain sizes vary — a cup can be off by enough to move the SG. Weigh the mix when you can.
  • Pouring a fresh batch straight into the tank. Undissolved mix and a fresh batch are how salinity swings happen — mix in a separate container with a pump or powerhead and let it clear fully first.
  • Adding dry salt near livestock. Dry salt burns corals — dissolve it fully in a separate container first.
  • Raising a stocked tank's salinity too fast. With corals and invertebrates, raise at most about 0.001 SG per day — a big jump in one dose stresses everything in the tank.

Salt mix per US gallon of RO/DI water

Grams of mix for one US gallon (3.78541 litres) of fresh RO/DI water at each target SG, by this tool's formula (grams = litres × ppt). The last column is the figure a calculator with a 1.07 salt factor gives for the same gallon — the difference is explained in the FAQ.

Target SGpptGrams per gallon (this tool)With 1.07 salt factor
1.01013.350.3 g55 g
1.01519.975.5 g82 g
1.02026.6100.6 g111 g
1.02330.5115.6 g128 g
1.02431.9120.6 g133 g
1.02533.2125.6 g139 g
1.02634.5130.6 g145 g

Read the two grams columns as two methods, not as a range to pick from: this tool uses the left column, and the finished water must be checked with a refractometer either way.

FAQ

Why does another calculator give more grams than this one?

It uses a different formula. The other calculator divides by (1,000 − S) and multiplies by a salt factor of 1.07 — grams of mix per gram of dissolved salt — so for 10 US gallons to SG 1.025 it gives 1,390 g where this tool gives 1,256 g, and for raising 50 gallons from 1.023 to 1.025 it gives 571 g where this tool gives 500 g. This tool uses grams = litres × change in ppt with no salt factor, so it reads lower. Both are estimates — brand label directions vary — so verify the finished water with a refractometer and add more mix if it reads low.

How accurate are the cups?

Not very. One cup is taken as about 270 g here, but grain size and packing change it, and another calculator uses 280 g per cup. Cups are a scoop estimate for when no scale is handy; weigh the mix when you can, and always confirm with a refractometer.

Can I mix salt straight into the tank?

No. Mix in a separate container with a pump or powerhead, match the temperature, and let it clear fully before it touches livestock. Dry salt near corals burns them, and a fresh batch poured straight in swings the salinity.

How fast can I raise the salinity of a stocked tank?

Slowly — about 0.001 SG per day at most with corals and invertebrates. This tool gives the total grams for the jump, not a daily schedule; split a big rise across days and test between doses.

Why does the reading drift after mixing?

Freshly mixed salt water is still dissolving and warming up, so a reading taken too soon is wrong. Wait until the batch is clear and at temperature — about an hour — before testing and adjusting.

Does the tool work from water that already has salt in it?

Yes. Enter the current SG and the target SG and it works out only the extra salt needed — for example 10 litres from SG 1.020 to 1.025 takes 66 g, not the full 332 g a fresh batch would need. If the target is at or below the current SG, it returns no salt needed.

Sources

  1. Peer-reviewed — Millero & Poisson (1981). International one-atmosphere equation of state of seawater. Deep-Sea Research 28A: 625–629. Used for the EOS-80 densities behind the ppt figures (SG 1.025 = 33.19 ppt, not 35 ppt).
  2. Standard — UNESCO (1981). Technical Papers in Marine Science 36 (PSS-78 / EOS-80). Used for the equation of state and the practical salinity scale.
  3. Textbook — Millero, F. J., Chemical Oceanography, CRC Press. Used for the seawater chemistry behind the salt-mass calculation.
  4. Hobby practice — the salt-mix calculator formula with a 1.07 salt factor. Cited only as the disputed figure (1,390 g for 10 US gallons to SG 1.025, against this tool's 1,256 g), with the difference explained in the FAQ; its dose is not used.

These are journal papers, a standard and a textbook, listed by name; no web link was on file for them.

Related tools