Enter your reef test results and see each one judged against the right ranges for your tank type — SPS, mixed, soft coral or fish-only — plus whether calcium and alkalinity are balanced and your nitrate:phosphate ratio. Worked example: a mixed reef testing alk 6 dKH, Ca 470 ppm, Mg 1,150 ppm, NO₃ 5 ppm and PO₄ 0.05 ppm has 3 readings out of range, with calcium +57 ppm over the 412.9 ppm expected at 6 dKH and an N:P ratio of 100:1 by mass. Blank fields are skipped, never guessed. This checker describes readings against ranges only — it never diagnoses a tank problem. Everything runs in your browser; nothing is saved.
How it works
Every reading you enter is judged against the range for your tank type, and only against that range. SPS corals calcify fastest, so they run the tightest ranges; soft corals and fish-only tanks tolerate wider ones. Blank fields are skipped, never guessed — any one test result is enough for a verdict.
Per-parameter verdict: below the range is low, inside is in range, above is high. The ranges come from Holmes-Farley (Reefkeeping Magazine): calcium 380–450 ppm, alkalinity 7–11 dKH, magnesium 1,250–1,350 ppm with up to 1,400 ppm acceptable. Natural seawater sits near calcium 420 ppm and magnesium 1,280 ppm (Millero, Chemical Oceanography).
Calcium/alkalinity balance: expected Ca = 420 + (Alk − 7) × 7.15. Skeleton building consumes about 7.15 ppm of calcium per 1 dKH of alkalinity, so the calcium expected for a given alkalinity is 420 ppm at 7 dKH, rising 7.15 ppm for each dKH above that. Balanced means the measured calcium is within ±40 ppm of expected. A calcium number that looks high on its own may only mean alkalinity is low — the balance check catches that.
Nitrate:phosphate ratio: mass = NO₃ ppm ÷ PO₄ ppm; molar = (NO₃ ÷ 62.00) ÷ (PO₄ ÷ 94.97). Redfield (1958) put the ratio of marine plankton at 16:1 molar, about 10:1 by mass — but many healthy reefs run 50–150:1 by mass, so the ratio is context for the two numbers, not a problem on its own.
Fix order: magnesium first, then alkalinity. Below about 1,250 ppm, magnesium cannot hold calcium and alkalinity up at the same time, so magnesium is fixed first (no more than about 50 ppm a day), then alkalinity (no more than 1 dKH per day), and calcium is left to fall on its own as corals use it. Fix one parameter at a time, slowly.
Worked example
A mixed reef testing alkalinity 6 dKH, calcium 470 ppm, magnesium 1,150 ppm, nitrate 5 ppm and phosphate 0.05 ppm.
Mixed reef: Alk 6 dKH, Ca 470 ppm, Mg 1,150 ppm, NO₃ 5 ppm, PO₄ 0.05 ppm.
Expected Ca = 420 + (Alk − 7) × 7.15. Balanced if |Ca − expected| ≤ 40 ppm. N:P mass = NO₃ ÷ PO₄.
Alk 6 is below 7 → low. Ca 470 is above 450 → high. Mg 1,150 is below 1,250 → low. NO₃ 5 and PO₄ 0.05 are inside their ranges. Expected Ca = 420 + (6 − 7) × 7.15 = 420 − 7.15 = 412.9 ppm, so calcium is 470 − 412.9 = +57 ppm over. N:P = 5 ÷ 0.05 = 100:1 by mass, (5 ÷ 62.00) ÷ (0.05 ÷ 94.97) = 153:1 molar.
3 out of range — alkalinity low, calcium high, magnesium low. Not balanced: raise alkalinity, not calcium. Fix magnesium first.
The same readings in a balanced tank look very different: at alkalinity 8 dKH and calcium 427 ppm, the expected calcium is 427.2 ppm — only about 0 ppm off, balanced. And the balance boundary is exact: at 7 dKH, calcium 460 ppm (+40) is balanced, but 461 ppm (+41) is not.
How to read your results
The verdict word is the headline: "All tested readings are in range" or "3 out of range". Under it, the pair line gives the tank type and how many readings were tested, and the stat grid shows the tested count, the out-of-range count, the expected calcium where alkalinity and calcium were both entered, and the N:P ratio where nitrate and phosphate were both entered.
Each parameter gets its own row. "Needs action" means that reading sits outside its range — low or high. "OK" means it sits inside. "Caution" appears on the calcium/alkalinity balance row when the two are out of balance. The "Fix order" list at the bottom is the order to work in: magnesium first, then alkalinity, one parameter at a time — and retest with fresh reagent before dosing, since a single odd result is often a test error.
The N:P ratio row is always "OK" — it is context, not a verdict. Redfield is 16:1 molar (about 10:1 by mass), but many healthy reefs run 50–150:1 by mass, so a 100:1 ratio on its own is not a problem.
Common mistakes
- Dosing calcium to chase a high reading while alkalinity is low. The imbalance is the problem, not the calcium number alone — raise alkalinity, not calcium, and let calcium fall as corals use it.
- Fixing alkalinity before magnesium. Below about 1,250 ppm, magnesium cannot hold calcium and alkalinity up at the same time — fix magnesium first.
- Dosing on a single odd result. A single odd reading is often a test error: retest with fresh reagent before dosing anything.
- Chasing a perfect number instead of stability. A reef steady at 8 dKH does better than one chased up and down between 7 and 10.
- Reading undetectable nitrate and phosphate as clean water. In a coral tank, undetectable nitrate and phosphate usually means corals are starving, not that the water is clean.
- Judging calcium or alkalinity alone. A calcium of 470 ppm looks high — but at 6 dKH the expected calcium is only 412.9 ppm, so the real problem is the low alkalinity. Always check the balance.
Target ranges by tank type
Every range this checker judges against, by tank type. All figures from the research in "Sources" below; SPS runs tighter than mixed or soft coral because it calcifies fastest, and fish-only is widest on salinity, nitrate and phosphate.
| Parameter | Mixed | SPS | Soft | Fish-only |
|---|---|---|---|---|
| Salinity (SG) | 1.025–1.026 | 1.025–1.026 | 1.025–1.026 | 1.020–1.025 |
| Temp (°F) | 76–80 | 76–80 | 76–80 | 76–80 |
| pH | 7.8–8.4 | 7.8–8.4 | 7.8–8.4 | 7.8–8.4 |
| Alk (dKH) | 7–11 | 7–9 | 7–11 | 7–11 |
| Ca (ppm) | 400–450 | 410–450 | 380–450 | 380–450 |
| Mg (ppm) | 1,250–1,400 | 1,250–1,400 | 1,250–1,400 | 1,250–1,400 |
| NO₃ (ppm) | 2–10 | 1–5 | 2–15 | 0–40 |
| PO₄ (ppm) | 0.03–0.10 | 0.02–0.08 | 0.03–0.15 | 0–0.5 |
| K (ppm) | 380–420 | 380–420 | 380–420 | 380–420 |
| Iodine (ppm) | 0.04–0.08 | 0.04–0.08 | 0.04–0.08 | 0.04–0.08 |
| Sr (ppm) | 7–10 | 7–10 | 7–10 | 7–10 |
Read it as the checker's rulebook: a reading is only judged against its own tank type's column, and the trace rows (potassium, iodine, strontium) are the same for every type.
FAQ
Why does the tank type change the ranges?
Because different corals calcify at different rates. SPS corals calcify fastest, so they run the tightest ranges — alkalinity 7–9 dKH and nitrate 1–5 ppm, against 7–11 dKH and 2–10 ppm for a mixed reef. Soft corals tolerate wider nitrate (2–15 ppm), and a fish-only tank tolerates far wider still (nitrate 0–40 ppm, phosphate 0–0.5 ppm).
My calcium is high but my alkalinity is low. Which do I fix?
The alkalinity. Skeleton building consumes about 7.15 ppm of calcium per 1 dKH of alkalinity, so the two move together — at 6 dKH the expected calcium is only 412.9 ppm, and a 470 ppm reading is +57 ppm over. Raise alkalinity (no more than 1 dKH per day) and let calcium fall on its own as corals use it. Do not dose calcium to chase a high reading while alkalinity is low.
Why fix magnesium first?
Below about 1,250 ppm, magnesium cannot hold calcium and alkalinity up at the same time — dosing either of them first will not stick. Raise magnesium slowly (no more than about 50 ppm a day) and retest, then work on alkalinity.
What does the N:P ratio tell me?
Mostly context. Redfield put the ratio of marine plankton at 16:1 molar (about 10:1 by mass), but many healthy reefs run 50–150:1 by mass. A 100:1 ratio on its own is not a problem — what matters is whether nitrate and phosphate are each detectable and in range. Undetectable nitrate and phosphate in a coral tank usually means corals are starving, not that the water is clean.
One reading looks wrong and the rest are fine. Should I dose?
No — retest first, with fresh reagent. A single odd result is often a test error, and dosing on it can push a healthy tank out of range. Fix one parameter at a time, slowly, and retest after any change.
Is a steady 8 dKH better than chasing 9?
Yes. Stability matters more than a perfect number — a reef steady at one value does better than one chased up and down. Test weekly, dose only what the tests say is missing, and retest after any change.
What if I only ran one test?
That is enough. Blank fields are skipped, never guessed — enter only the tests you ran and the checker judges those. It will not show a calcium/alkalinity balance without both readings, or an N:P ratio without both nitrate and phosphate.
Sources
- Textbook — Millero, F. J., Chemical Oceanography, CRC Press. Natural seawater: calcium about 412 mg/kg, magnesium about 1,290, potassium about 399, strontium about 8 mg/kg at salinity 35. Used for the seawater reference levels and the expected-calcium anchor of 420 ppm.
- Hobby practice — Holmes-Farley, R., Reefkeeping Magazine / Advanced Aquarist. Reef water parameters, calcium/alkalinity balance and magnesium. Used for the ranges (Ca 380–450 ppm, alkalinity 7–11 dKH, Mg 1,250–1,350 ppm with up to 1,400 acceptable) and the fix order (magnesium first, then alkalinity).
- Peer-reviewed — Redfield, A. C. (1958). The biological control of chemical factors in the environment. American Scientist 46(3): 205–221. Used for the 16:1 molar N:P ratio of marine plankton (about 10:1 by mass).
No web link is given for these sources because none is on file — the figures come from the printed references named above.