Work out whether kalkwasser (limewater) alone can meet your reef tank's daily alkalinity demand — and how much of it your daily evaporation can actually carry. Kalk is the cheapest reef dosing method, but it can only deliver what evaporation allows, so this calculator shows the evaporation ceiling plainly and gives you the exact shortfall to cover with two-part dosing when it can't keep up. Saltwater reef tool, intermediate level. Everything runs in your browser; nothing is saved.
How it works
Kalkwasser is saturated calcium hydroxide solution — Ca(OH)₂ in RO/DI water. Dosed as top-off water through an ATO, it replaces evaporated water with water that carries alkalinity and calcium in the ratio corals use them. That is the whole constraint of the method: kalk can only enter the tank as fast as water leaves it, so the daily evaporation sets a hard ceiling on the daily dose.
Daily kalk (mL) = daily Alk demand (dKH) ÷ 0.00114 × (system litres ÷ 100). Saturated kalkwasser adds about 0.00114 dKH per mL per 100 litres of system water — about 40 meq/L of alkalinity and about 800 ppm of calcium, the ReefMath figures this tool uses.
Maximum daily kalk (mL) = daily evaporation (litres) × 1,000. Kalk is dosed as top-off water, so a tank that evaporates 1 litre a day can take at most 1,000 mL of kalk a day.
Most Alk kalk can cover (dKH/day) = maximum kalk (mL) × 0.00114 ÷ (system litres ÷ 100). If the demand is higher, the shortfall is the demand minus this ceiling, in dKH/day and in mL/day.
Calcium added (ppm/day) ≈ kalk (mL/day) × 0.8 ÷ system litres. Saturated kalk is about 800 ppm calcium, so each mL carries about 0.8 mg of calcium, spread over the system volume. This figure is approximate — the tool shows it with a "~" and the page says so wherever it appears.
A second route to the same numbers, and why it differs slightly. The CRC Handbook gives calcium hydroxide solubility of about 1.6 g/L at 25 °C, which is about 43 meq/L of alkalinity and 866 mg/L of calcium at full saturation. At 90% saturation efficiency that is 1.09 dKH/day and 7.8 ppm of calcium for 1 gallon of kalk top-off a day in a 100-gallon reef — against this tool's 1.14 dKH/day and 8.0 ppm. The two routes agree within about 5%: the tool's 0.00114 constant implies about 40 meq/L, between the 90%-efficient figure and full saturation. Treat both as the same answer within test-kit error, and always confirm with an alkalinity test, not by trusting either figure to the second decimal.
Mixing. About 2 teaspoons (6 g) of calcium hydroxide powder per US gallon of top-off water makes a saturated mix; excess powder settles undissolved at the bottom. Keep the reservoir covered — air turns kalk into useless calcium carbonate — and mix fresh batches rather than storing one for weeks.
Worked example
A 100-litre system, daily alkalinity demand 1 dKH/day, daily evaporation 1 litre.
System 100 L; demand 1 dKH/day; evaporation 1 L/day.
Kalk (mL) = demand ÷ 0.00114 × (litres ÷ 100). Max kalk = evaporation × 1,000.
1 ÷ 0.00114 × (100 ÷ 100) = 877 mL/day of saturated kalk. Maximum: 1 × 1,000 = 1,000 mL/day. 877 is less than 1,000, so it fits — using 87.7% of the daily evaporation. Calcium: 877 × 0.8 ÷ 100 = about 7.0 ppm/day.
Kalk can cover it — 877 mL/day, inside the 1,000 mL evaporation ceiling, adding about 7.0 ppm of calcium a day.
The same tank with only 0.5 litres of evaporation a day: the ceiling is 500 mL/day, which covers only 0.57 dKH/day, so the shortfall is 377 mL/day of kalk, or 0.43 dKH/day to cover with two-part dosing.
And the larger case from the research notes, through this tool's own figures: a 100-gallon reef (378.5 L), 1 gallon (3.785 L) of top-off a day, all kalk, demand 1.5 dKH/day. The tool needs 4,980 mL/day against a 3,785 mL ceiling, so it does not fit — the ceiling covers 1.14 dKH/day, leaving a shortfall of 0.36 dKH/day. The saturation-chemistry route gives 1.09 dKH/day for the same case, about 5% lower; either way, kalk alone cannot meet a 1.5 dKH/day demand on 1 gallon of evaporation.
How to read your results
The verdict word is the headline: "Kalk can cover it" when the dose fits inside evaporation, "Kalk can cover it — barely" when it fits but uses over 90% of the daily evaporation, or "Evaporation can't carry that much kalk" when it does not fit. The stat grid shows the three numbers behind it — the kalk needed in mL/day, the evaporation ceiling in mL/day, and the calcium added in ppm/day (approximate).
When it does not fit, the "Needs action" row gives the shortfall in dKH/day — that is the amount to cover with two-part dosing, worked out on the Reef Dosing Calculator. The ceiling in dKH/day is the most alkalinity kalk can ever add to your tank, whatever the demand; it only rises if evaporation rises.
"Caution" rows are the ones to respect even when the verdict is green: over 90% of evaporation leaves almost no headroom, because evaporation changes with the seasons and with fans or a lid; and a daily demand above 1.4 dKH is unusually high — re-test alkalinity before trusting it, and never raise alkalinity by more than 1.4 dKH in a single day.
Common mistakes
- Dosing more kalk than evaporation allows. Kalk only enters as top-off water — any dose above evaporation is water the tank did not lose, so salinity falls and pH spikes. The ceiling is not a suggestion.
- Guessing the daily demand. Demand must be measured from two Alk tests days apart with no dosing in between — a guessed demand makes the whole answer fiction.
- Pouring kalk in instead of dripping it. Saturated kalk is pH 12.4; a fast dose spikes pH and can precipitate calcium carbonate as a white cloud in the tank. Drip it slowly into high flow.
- Using this tool to fix a low alkalinity reading. It matches daily consumption; it does not raise Alk. A correction dose belongs on the Reef Dosing Calculator.
- Leaving the kalk reservoir open. Air turns kalk into useless calcium carbonate, so an uncovered reservoir quietly stops dosing anything.
- Running the ATO without a failsafe. A stuck float can dump the whole reservoir and spike pH — an ATO failsafe is part of the method, not an accessory.
- Topping off with salt water. Salts do not evaporate, so topping off with salt water creeps salinity up. Top off with kalkwasser or fresh RO/DI only.
What kalk adds per gallon of top-off (100-gal reef, all top-off kalk)
Alkalinity and calcium added per day for each daily top-off volume, computed with this tool's own figures (0.00114 dKH per mL per 100 L; about 800 ppm calcium). The saturation-chemistry figures for the same cases are about 5% lower — 0.54 dKH and 3.9 ppm at half a gallon, 1.09 dKH and 7.8 ppm at one gallon — because they assume 90% saturation efficiency against the CRC full-saturation value of about 43 meq/L.
| Top-off/day | Alk added | Ca added |
|---|---|---|
| 0.5 gal | 0.57 dKH/day | 4.0 ppm/day |
| 1.0 gal | 1.14 dKH/day | 8.0 ppm/day |
| 1.5 gal | 1.71 dKH/day | 12.0 ppm/day |
| 2.0 gal | 2.28 dKH/day | 16.0 ppm/day |
Read the table as a ceiling, not a dose: it shows what each top-off volume can carry, and your tank can only use the row its evaporation reaches. A 100-gallon reef evaporating 1 gallon a day can add at most 1.14 dKH/day as kalk, whatever its corals demand.
FAQ
Can kalkwasser alone run my reef?
Only if your daily alkalinity demand fits inside your daily evaporation. Low-demand reefs often can; SPS-heavy reefs usually cannot, because the corals use more alkalinity than the evaporated water can carry back in. This tool gives the yes-or-no answer for your measured demand and evaporation — and the shortfall to cover with two-part dosing when the answer is no.
Why is my kalk dose capped by evaporation?
Kalk is dosed as top-off water, and top-off only replaces water the tank lost. Dosing more kalk than evaporation means adding water the tank did not lose, so salinity falls and the pH 12.4 solution spikes the tank's pH. The ceiling is the method itself, not a safety margin.
How do I measure my daily demand and evaporation?
Demand: two alkalinity tests days apart with no dosing in between — the fall divided by the days is the demand. Evaporation: mark the water level, wait a week without topping off, and divide the volume lost by seven. Both must be measured; neither can be guessed from the tank size.
Is the 0.00114 figure exact?
No — it is ReefMath's published figure for saturated kalkwasser, about 40 meq/L of alkalinity and about 800 ppm of calcium. The CRC Handbook's full-saturation value is about 43 meq/L and 866 mg/L of calcium, and at 90% efficiency that gives figures about 5% lower than the tool's. The difference is smaller than test-kit error; confirm with an alkalinity test rather than trusting either figure to the second decimal.
Why does the tool say my calcium too — do I still need to test it?
Yes. The calcium figure is approximate (saturated kalk is "about" 800 ppm calcium), and it assumes the kalk is fully saturated and the dose is the one shown. Test calcium regularly; the tool's figure tells you roughly what to expect, not what the tank holds.
Can I use kalk to raise a low alkalinity reading?
No. Kalk matches daily consumption; raising a low reading by more than 1.4 dKH in a single day stresses the tank, and kalk dosed faster than evaporation allows spikes pH. Work out the correction dose on the Reef Dosing Calculator and the daily use on the Reef Daily Consumption Planner.
What if my ATO fails with kalk in it?
A stuck float can dump the whole reservoir and spike pH sharply — that is the main kalk accident. Use an ATO with a failsafe (a second float or a timer limit), keep the reservoir covered so air does not turn the kalk into useless calcium carbonate, and mix fresh batches rather than storing one for weeks.
Sources
No source URLs are on file for these references, so they are listed by name without links. One figure carries an explicit uncertainty — see the first entry.
- Hobby practice — ReefMath kalkwasser dosing calculator. Source of the 0.00114 dKH per mL per 100 L constant (about 40 meq/L alkalinity, about 800 ppm calcium) this tool uses. The constant was read from ReefMath's published calculator and was not live-verified against the ReefMath page in this build, and other reef sources round the same figure differently — the saturation-chemistry cross-check in "How it works" shows the size of that difference (about 5%).
- Textbook — Haynes (ed.), CRC Handbook of Chemistry and Physics. Calcium hydroxide solubility about 1.6 g/L at 25 °C, giving about 43 meq/L of alkalinity and 866 mg/L of calcium at full saturation. Used for the cross-check against the tool's figures, and for the 2-teaspoon (6 g) per gallon mixing ratio.
- Hobby practice — Holmes-Farley, R., Reefkeeping Magazine / Advanced Aquarist. Kalkwasser through top-off, the pH effect of dosing, and loss to atmospheric CO₂. Used for the covered-reservoir, slow-drip and pH guidance.
- Standard — APHA / AWWA / WEF, Standard Methods, Method 2320. 1 dKH = 0.3566 meq/L. Used to convert between the dKH figures on this page and the meq/L figures in the chemistry references.
- Hobby practice — Bulk Reef Supply guidance, via ReefCalcs / Seafan. Never raise alkalinity by more than 1.4 dKH in a single day, and the pH 12.4 slow-drip warning. Used for the daily-rise limit and the dosing caution on this page.